Skip to contentSkip to conversation

cciss: remove errant debug code

PATCH New Mike Miller 1 participant 1 message Jun 4, 2010

Subsystems (2)
SCSI Block layer
lore
Share & tools
lore

Mike Miller

author
#0 lore raw

PATCH 4/5 cciss: remove errant debug code

Patch 4 of 5
cciss: remove a debug statement left behind by accident
Ths debug statement got left behind. It was commented out after use but not deleted.

From: Mike Miller <[email protected]>

Signed-off-by Mike Miller <[email protected]>
Cc Stephen M. Cameron <[email protected]>, [email protected]
---
 drivers/block/cciss_scsi.c |    2 --
 1 files changed, 0 insertions(+), 2 deletions(-)
drivers/block/cciss_scsi.c +0 -2
index df26a4f..f89726d 100644
@@ -213,8 +213,6 @@ scsi_cmd_stack_setup(int ctlr, struct cciss_scsi_adapter_data_t *sa)
 
 	/* Check alignment, see cciss_cmd.h near CommandList_struct def. */
 	BUILD_BUG_ON((sizeof(*stk->pool) % COMMANDLIST_ALIGNMENT) != 0);
-	/* printk(KERN_WARNING "cciss_scsi.c: 0x%08x 0x%08x 0x%08x\n",
-			0xdeadbeef, sizeof(*stk->pool), 0xbeefdead); */
 	/* pci_alloc_consistent guarantees 32-bit DMA address will be used */
 	stk->pool = (struct cciss_scsi_cmd_stack_elem_t *)
 		pci_alloc_consistent(hba[ctlr]->pdev, size, &stk->cmd_pool_handle);