USB fixes for 2.6.35-git

Here are a few USB bugfixes for your 2.6.35-git tree.

The majority are for the s3c gadget driver, and the xhci host controller, with a smattering of other bugfixes.

Please pull from:

	master.kernel.org:/pub/scm/linux/kernel/git/gregkh/usb-2.6.git/

Most of these patches have been in the linux-next and mm trees.

The full patches will be sent to the linux-usb mailing list, if anyone wants to see them.

thanks,

greg k-h

------------

 drivers/usb/class/cdc-acm.c          |    6 ++-
 drivers/usb/core/driver.c            |    2 +
 drivers/usb/gadget/Kconfig           |    1 +
 drivers/usb/gadget/s3c-hsotg.c       |   57 ++++++++++++++++++++++++++++++++++
 drivers/usb/host/ehci-hcd.c          |   20 ++++++++++--
 drivers/usb/host/isp1362.h           |    2 +-
 drivers/usb/host/xhci-pci.c          |    2 +
 drivers/usb/host/xhci-ring.c         |   31 ++++++++++++++++++-
 drivers/usb/host/xhci.c              |   57 +++++++++++++++++++++++++++++-----
 drivers/usb/host/xhci.h              |   12 +++++++
 drivers/usb/serial/digi_acceleport.c |    3 +-
 drivers/usb/serial/ftdi_sio.c        |    4 ++
 drivers/usb/serial/mos7840.c         |    1 -
 13 files changed, 180 insertions(+), 18 deletions(-)

---------------

Alan Stern (1):
USB: unbind all interfaces before rebinding them

Axel Lin (1):
USB: cdc-acm: fix resource reclaim in error path of acm_probe

Ben Dooks (3):
USB: s3c-hsotg: Ensure TX FIFO addresses setup when initialising FIFOs
USB: s3c-hsotg: SoftDisconnect minimum 3ms
USB: s3c-hsotg: Ensure FIFOs are fully flushed after layout

Daniel Mack (1):
USB: ftdi_sio: fix DTR/RTS line modes

Grant Likely (1):
usb: fix ehci_hcd build failure when both generic-OF and xilinx is selected

Johan Hovold (1):
USB: mos7840: fix null-pointer dereference

Julia Lawall (1):
USB: serial: digi_acceleport: Eliminate a NULL pointer dereference

Maurus Cuelenaere (1):
USB: s3c_hsotg: define USB_GADGET_DUALSPEED in Kconfig

Mike Frysinger (1):
USB: isp1362: fix inw warning on Blackfin systems

Sarah Sharp (3):
USB: xhci: Wait for controller to be ready after reset.
USB: xhci: Wait for host to start running.
USB: xhci: Print NEC firmware version.

Thomas Abraham (1):
USB: s3c: Enable soft disconnect during initialization