Skip to contentSkip to conversation

Query dw_dmac driver: All descriptors done, but channel not idle!

DISCUSSION Viresh KUMAR 2 participants 3 messages Jun 18, 2010

lore
Share & tools
lore
#0 lore raw

Hello,

We have Synopsys Designware DMAC Controller on ST SPEAr13xx platform. When i run dmatest for all 8 channels then i see following error some times.

"dma dma0chan7: BUG: All descriptors done, but channel not idle!"

I saw the code in driver, and i think it looks to be a known issue for this peripheral, that's why special handling is done in driver.

Can somebody please confirm, if it a known issue or not? Or if there are some solutions for this problem.

viresh.

#1 lore raw
Quoted 2 lines · Viresh KUMAR

Can somebody please confirm, if it a known issue or not? Or if there are some solutions for this problem.

I'm not aware of any such issue. The code was added as a purely defensive thing; when writing it, I just thought about what might happen if we go through all our descriptors without finding the current one, and added some code to report the issue and try to recover.

I suppose it might be caused by some issue with the peripheral itself, but I think it's more likely to be caused by some race condition in the driver, i.e. something goes wrong when inserting or removing descriptors in the chain.

What might be very good to know at this point is the value of the llp variable, and perhaps also the value of the CH_EN register to see if the channel is idle or not.

Haavard

#2 lore raw
Quoted 9 lines · Haavard Skinnemoen
Quoted 2 lines · Viresh KUMAR

Can somebody please confirm, if it a known issue or not? Or if there are some solutions for this problem.

I'm not aware of any such issue. The code was added as a purely defensive thing; when writing it, I just thought about what might happen if we go through all our descriptors without finding the current one, and added some code to report the issue and try to recover.

Quoted 9 lines

I suppose it might be caused by some issue with the peripheral itself, but I think it's more likely to be caused by some race condition in the driver, i.e. something goes wrong when inserting or removing descriptors in the chain.

What might be very good to know at this point is the value of the llp variable, and perhaps also the value of the CH_EN register to see if the channel is idle or not.

Thanks Haavard,

Will debug it further.

viresh.