hwmon: (w83795) Only start monitoring if
Subsystems (2)
PATCH 13/36 hwmon: (w83795) Only start monitoring if
This saves an SMBus write if monitoring was already enabled.
Signed-off-by Jean Delvare <[email protected]>
--- drivers/hwmon/w83795.c | 13 ++++++++++--- 1 file changed, 10 insertions(+), 3 deletions(-)
drivers/hwmon/w83795.c +10 -3
@@ -55,6 +55,7 @@ MODULE_PARM_DESC(reset, "Set to 1 to res#define W83795_REG_I2C_ADDR 0xfc#define W83795_REG_CONFIG 0x01#define W83795_REG_CONFIG_CONFIG48 0x04 +#define W83795_REG_CONFIG_START 0x01/* Multi-Function Pin Ctrl Registers */ #define W83795_REG_VOLT_CTRL1 0x02
@@ -1664,12 +1665,18 @@ static const struct sensor_device_attribstatic void w83795_init_client (struct i2c_client *client) { +u8 config; +if (reset)w83795_write (client,W83795_REG_CONFIG ,0x80 ); -/* Start monitoring */ -w83795_write (client,W83795_REG_CONFIG , -w83795_read (client,W83795_REG_CONFIG ) |0x01 ); +/* Start monitoring if needed */ + config =w83795_read (client,W83795_REG_CONFIG ); +if (!(config &W83795_REG_CONFIG_START )) { +dev_info (&client->dev,"Enabling monitoring operations\n" ); +w83795_write (client,W83795_REG_CONFIG , + config |W83795_REG_CONFIG_START ); + } }static int w83795_get_device_id (struct i2c_client *client)
_______________________________________________
lm-sensors mailing list
[email protected]
http://lists.lm-sensors.org/mailman/listinfo/lm-sensors