mpc831xerdb: enable mtdparts for NAND
PATCH 1/1 mpc831xerdb: enable mtdparts for NAND
The default partition table matches the .dts files for these boards in Linux. This allows these partitions to be used by name with U-Boot's "nand" command.
Signed-off-by Scott Wood <[email protected]>
--- include/configs/MPC8313ERDB.h | 9 ++++++++- include/configs/MPC8315ERDB.h | 9 ++++++++- 2 files changed, 16 insertions(+), 2 deletions(-)
include/configs/MPC8313ERDB.h +8 -1
@@ -1,5 +1,5 @@/* -* Copyright (C) Freescale Semiconductor, Inc. 2006. +* Copyright (C) Freescale Semiconductor, Inc. 2006, 2010. * * See file CREDITS for list of people who contributed to this * project.
@@ -232,6 +232,13 @@#define CONFIG_SYS_NAND_BASE 0xE2800000#endif +#define CONFIG_MTD_DEVICE +#define CONFIG_MTD_PARTITION +#define CONFIG_CMD_MTDPARTS +#define MTDIDS_DEFAULT "nand0=e2800000.flash" +#define MTDPARTS_DEFAULT \ + "mtdparts=e0600000.flash:512k(uboot),128k(env),3m at 1m(kernel),-(fs)" +#define CONFIG_SYS_MAX_NAND_DEVICE 1#define CONFIG_MTD_NAND_VERIFY_WRITE #define CONFIG_CMD_NAND 1
include/configs/MPC8315ERDB.h +8 -1
@@ -1,5 +1,5 @@/* -* Copyright (C) 2007-2009 Freescale Semiconductor, Inc. +* Copyright (C) 2007-2010 Freescale Semiconductor, Inc. * * Dave Liu <[email protected]> *
@@ -243,6 +243,13 @@#define CONFIG_SYS_NAND_BASE 0xE0600000#endif +#define CONFIG_MTD_DEVICE +#define CONFIG_MTD_PARTITION +#define CONFIG_CMD_MTDPARTS +#define MTDIDS_DEFAULT "nand0=e0600000.flash" +#define MTDPARTS_DEFAULT \ + "mtdparts=e0600000.flash:512k(uboot),128k(env),3m at 1m(kernel),-(fs)" +#define CONFIG_SYS_MAX_NAND_DEVICE 1#define CONFIG_MTD_NAND_VERIFY_WRITE 1#define CONFIG_CMD_NAND 1
Signature · 1 line
1.7.0.4
PATCH 1/1 mpc831xerdb: enable mtdparts for NAND
Quoted 6 lines · On Mon, 30 Aug 2010 18:04:52 -0500 Scott Wood <[email protected]> wrote:
The default partition table matches the .dts files for these boards in Linux. This allows these partitions to be used by name with U-Boot's "nand" command.
Signed-off-by Scott Wood <[email protected]>---
applied to u-boot-mpc83xx/next.
Thanks,
Kim