Skip to contentSkip to conversation

The board hangs while PCI-init

U-Boot sywang 3 participants 3 messages Sep 23, 2010

lore
Share & tools
lore

sywang

author
#0 lore raw

Hello, everyone,

I try to bring the u-boot up on the board with Cavium CN5010. When pci-init is executed on the board_init_r, the board will hang. Did you have such a question before? Any suggestions are welcome.

Thanks!

Shuyou

#1 lore raw
Quoted 5 lines

I try to bring the u-boot up on the board with Cavium CN5010. When pci-init is executed on the board_init_r, the board will hang. Did you have such a question before? Any suggestions are welcome.

If you have a logic analyzer, try looking on the bus. I have seen a host processor hang when a slave device is issuing PCI retries. In my case, the PCI peripheral did not initialize its configuration space enable bit. (The BIOS on the host was not smart enough to just give up, it kept retrying).

Cheers,
Dave

#2 lore raw
In reply to sywang

Dear "sywang",

Quoted 4 lines · In message <[email protected]> you wrote:

I try to bring the u-boot up on the board with Cavium CN5010. When pci-init is executed on the board_init_r, the board will hang. Did you have such a question before? Any suggestions are welcome.

It will probably be difficult to get any help for this here. Cavium never bothered to ush their changes upstream, so we have no idea what sort of code you might be running. Try an contact Cavium technical support.

Best regards,

Wolfgang Denk

Signature · 6 lines
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
Nothing in progression can rest on its original plan. We may as  well
think  of  rocking  a grown man in the cradle of an infant.
- Edmund Burke