Skip to contentSkip to conversation

: x86: local_irq_save/restore when issuing IPI in early bootup

PATCH New Prarit Bhargava 1 participant 1 message Oct 5, 2010 x86

lore
Share & tools
lore
#0 lore raw

PATCH 1/1 : x86: local_irq_save/restore when issuing IPI in early bootup

Resending to wider audience. This was originally posted here

http://marc.info/?l=linux-kernel&m=128162059006512&w=2

When sending out an IPI interrupts are masked off. In the cpu wakeup code, this is not the case. Make the code consistent.

Alok Kataria noticed the following hang:

1. vcpu1 is doing wakeup_secondary_cpu_via_init() is booting all the other processors. It tries to bring each cpu up by sending an IPI which is done by writing the APIC ICR.

The call path is wakeup_secondary_cpu_via_init() which calls apic_icr_write-> native_apic_icr_write(). native_apic_icr_write() writes APIC_ICR2 and APIC_ICR in order to modify the ICRHI and ICRLO values.

The ICRHI is set to the number of online cpus.

The write to APIC_ICR does not happen because

2. vcpu1's physical cpu *may* take a timer interrupt which does lapic_timer_broadcast(), which calls send_IPI_mask(). send_IPI_mask() calls default_send_IPI_mask_sequence_phys() which changes the ICRHI value to the number of online vcpus -- which is one less than what it was set to in step 1.

3. return to thread in step 1 ... ICRHI is different and one less than the previous value. This results in the IPI being sent TWICE to the same vcpu (CPU X-1) instead of once to CPU X-1 and once to CPU X.

It may be that native_apic_icr_write() actually needs it's own irq save/restore, however, I cannot see a code path that requires it. A larger irq save/restore seems more appropriate around the IPI code which seems adequate given that other code does the same thing (see calls to __default_send_IPI_dest_field() ) and is not broken.

arch/x86/kernel/smpboot.c +5 -0
index 8b3bfc4..efa6c98 100644
@@ -580,6 +580,7 @@ wakeup_secondary_cpu_via_init(int phys_apicid, unsigned long start_eip)
 {
 	unsigned long send_status, accept_status = 0;
 	int maxlvt, num_starts, j;
+	unsigned long flags;
 
 	maxlvt = lapic_get_maxlvt();
 
@@ -600,6 +601,7 @@ wakeup_secondary_cpu_via_init(int phys_apicid, unsigned long start_eip)
 	/*
 	 * Send IPI
 	 */
+	local_irq_save(flags);
 	apic_icr_write(APIC_INT_LEVELTRIG | APIC_INT_ASSERT | APIC_DM_INIT,
 		       phys_apicid);
 
@@ -616,6 +618,7 @@ wakeup_secondary_cpu_via_init(int phys_apicid, unsigned long start_eip)
 
 	pr_debug("Waiting for send to finish...\n");
 	send_status = safe_apic_wait_icr_idle();
+	local_irq_restore(flags);
 
 	mb();
 	atomic_set(&init_deasserted, 1);
@@ -657,6 +660,7 @@ wakeup_secondary_cpu_via_init(int phys_apicid, unsigned long start_eip)
 		/* Target chip */
 		/* Boot on the stack */
 		/* Kick the second */
+		local_irq_save(flags);
 		apic_icr_write(APIC_DM_STARTUP | (start_eip >> 12),
 			       phys_apicid);
 
@@ -669,6 +673,7 @@ wakeup_secondary_cpu_via_init(int phys_apicid, unsigned long start_eip)
 
 		pr_debug("Waiting for send to finish...\n");
 		send_status = safe_apic_wait_icr_idle();
+		local_irq_restore(flags);
 
 		/*
 		 * Give the other CPU some time to accept the IPI.