Topcliff: Update PCH_GPIO driver to 2.6.35

Hi Mark,

I have modified for your comments.
Please check below.

Thanks, Ohtake(OKISemi)

---
GPIO driver of Topcliff PCH

Topcliff PCH is the platform controller hub that is going to be used in Intel's upcoming general embedded platform. All IO peripherals in Topcliff PCH are actually devices sitting on AMBA bus. Topcliff PCH has GPIO I/F. Using this I/F, it is able to access system devices connected to GPIO.

---
 drivers/gpio/Kconfig    |    8 ++
 drivers/gpio/Makefile   |    1 +
 drivers/gpio/pch_gpio.c |  312 +++++++++++++++++++++++++++++++++++++++++++++++
 3 files changed, 321 insertions(+), 0 deletions(-)
 create mode 100644 drivers/gpio/pch_gpio.c

index 7face91..f0876b1 100644
@@ -298,6 +298,14 @@ config GPIO_RDC321X
 	  Support for the RDC R321x SoC GPIOs over southbridge
 	  PCI configuration space.
 
+config GPIO_PCH
+	tristate "PCH GPIO of Intel Topcliff"
+	depends on PCI
+	help
+	  This driver is for PCH(Platform controller Hub) GPIO of Intel Topcliff
+	  which is an IOH(Input/Output Hub) for x86 embedded processor.
+	  This driver can access PCH GPIO device.
+
 comment "SPI GPIO expanders:"
 
 config GPIO_MAX7301

index e53dcff..a2ef754 100644
@@ -35,3 +35,4 @@ obj-$(CONFIG_GPIO_WM8994)	+= wm8994-gpio.o
 obj-$(CONFIG_GPIO_SCH)		+= sch_gpio.o
 obj-$(CONFIG_GPIO_RDC321X)	+= rdc321x-gpio.o
 obj-$(CONFIG_GPIO_JANZ_TTL)	+= janz-ttl.o
+obj-$(CONFIG_GPIO_PCH)		+= pch_gpio.o

1.6.0.6

The gpio tree is pretty much orphaned at the minute, I'd guess Andrew Morton (who's already CCed) would be the most likely person to pick this up since it's not a MFD device.