amba: add name based matching
PATCH 1/1 amba: add name based matching
Some peripherals on the DBx500 family of SoCs have changes in their functionality and registers between different variants in the family but retain the same AMBA peripheral ID, making it impossible to distinguish between them in AMBA drivers with the current AMBA id_table.
To support this, add a name parameter to the amba_device and the amba_id and allow name based matching as a second level filter after the periphid match.
--- drivers/amba/bus.c | 6 ++++++ include/linux/amba/bus.h | 2 ++ 2 files changed, 8 insertions(+), 0 deletions(-)
drivers/amba/bus.c +6 -0
@@ -28,6 +28,12 @@ amba_lookup(struct amba_id *table, struct amba_device *dev)while (table->mask) { ret = (dev->periphid & table->mask) == table->id; +if (ret && (table->name || dev->name)) { +if (table->name && dev->name) + ret =strcmp (dev->name, table->name) ==0 ; +else + ret =0 ; + }if (ret)break ; table++;
include/linux/amba/bus.h +2 -0
@@ -29,12 +29,14 @@ struct amba_device {struct clk *pclk;u64 dma_mask;unsigned int periphid; +const char *name;unsigned int irq[AMBA_NR_IRQS ]; };struct amba_id {unsigned int id;unsigned int mask; +const char *name;void *data; };
Signature · 1 line
1.7.1
PATCH 1/1 amba: add name based matching
Quoted 8 lines · Rabin Vincent
Some peripherals on the DBx500 family of SoCs have changes in their functionality and registers between different variants in the family but retain the same AMBA peripheral ID, making it impossible to distinguish between them in AMBA drivers with the current AMBA
id_table.To support this, add a name parameter to the
amba_deviceand theamba_idand allow name based matching as a second level filter after the periphid match.
I am really not very happy with this without an explaination of the kinds of differences there are.
We've been through these kinds of problems where hardware has claimed to be implemented by 'ARM' (0x41 in the implementer byte) "for compatibility" but are a different design with their own differences. Eventually the vendor was forced (as I understand by ARM Ltd) to change that.
This sounds like another one of these situations - it seems that the lesson hasn't been learnt.
PATCH 1/1 amba: add name based matching
Quoted 6 lines · Russell King - ARM Linux
Quoted 5 lines · Rabin Vincent
Some peripherals on the DBx500 family of SoCs have changes in their functionality and registers between different variants in the family but retain the same AMBA peripheral ID, making it impossible to distinguish between them in AMBA drivers with the current AMBA
id_table.
Quoted 6 lines
Quoted 3 lines
To support this, add a name parameter to the
amba_deviceand theamba_idand allow name based matching as a second level filter after the periphid match.I am really not very happy with this without an explaination of the kinds of differences there are.
For example:
- The PL180 derivate has the ID 0x00480180 on both DB8500v1 and DB8500v2, but the DB8500v2 version moves the BLOCKSIZE in the DATACTRL register from a power of two at bits 7:4 to a normal value at bits 30:16. The bits 7:4 become reserved in DB8500v2.
- The PL022 derivate has the ID 0x00080023 on DB8500 and DB5500, but the DB5500 version has the "Loopback enable" bit, while the DB8500 version doesn't.
Rabin