AT91: USB and DCACHE issue (was: ELF_RELOC causes strange I-cache issues)
Hi,
Quoted 23 lines
Quoted 23 lines
Quoted 23 lines
But with DCACHE ON, the USB Stick is not found - maybe a timing problem:
TOP9000> dc off
Data (writethrough) Cache is OFF
TOP9000> usb reset
(Re)start USB...
USB: scanning bus for devices... 2 USB Device(s) foundscanning bus for storage devices... 1 Storage Device(s) found
TOP9000> dc on
Data (writethrough) Cache is ON
TOP9000> usb reset
(Re)start USB...
USB: scanning bus for devices... ERROR: CTL:TIMEOUT
2 USB Device(s) foundscanning bus for storage devices... 0 Storage Device(s) found
TOP9000>
Reinhard
Quoted 8 lines
Quoted 4 lines
If the USB controller uses DMA, then the DCache issue probably has to do with making sure to flush the (relevant lines of) cache before memory-to-device DMAs and to invalidate the (again, relevant lines of) cache after device-to-memory DMAs.
Correct. Note that the EHCI driver already supports such a mode with d-cache enabled. You need to set
CONFIG_EHCI_DCACHEto enable these cache handling functions.
AT91 uses OHCI.
As far as I can tell there is no cache code in it. And I am not sure whether the USB RAM is cache inhibited. Do any other architectures work with DCACHE and OHCI?
Best Regards,
Reinhard
Quoted 8 lines · On Thursday 21 October 2010 13:22:10 Reinhard Meyer wrote:
Quoted 3 lines
Correct. Note that the EHCI driver already supports such a mode with d-cache enabled. You need to set
CONFIG_EHCI_DCACHEto enable these cache handling functions.AT91 uses OHCI.
As far as I can tell there is no cache code in it. And I am not sure whether the USB RAM is cache inhibited. Do any other architectures work with DCACHE and OHCI?
No, the OHCI code has no d-cache support right now. This needs to be added when used with d-cache enabled.
Cheers,
Stefan
--
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-0 Fax: (+49)-8142-66989-80 Email: office at denx.de