NUMA Hotplug emulator
Subsystems (5)
PATCH v2 7/8 NUMA Hotplug emulator
From: Shaohui Zheng <[email protected]>
Subject: hotplug emulator:extend memory probe interface to support NUMA
Extend memory probe interface to support an extra paramter nid, the reserved memory can be added into this node if node exists.
Add a memory section(128M) to node 3(boots with mem=1024m)
echo 0x40000000,3 > memory/probe
And more we make it friendly, it is possible to add memory to do
echo 3g > memory/probe echo 1024m,3 > memory/probe
It maintains backwards compatibility.
Signed-off-by Shaohui Zheng <[email protected]>
Signed-off-by Haicheng Li <[email protected]>
Signed-off-by Wu Fengguang <[email protected]>
---
arch/x86/Kconfig +0 -4
@@ -1273,10 +1273,6 @@ config ARCH_SELECT_MEMORY_MODEL def_bool y depends on ARCH_SPARSEMEM_ENABLE -config ARCH_MEMORY_PROBE - def_bool X86_64 - depends on MEMORY_HOTPLUG - config ILLEGAL_POINTER_VALUE hex default 0 if X86_32
drivers/base/memory.c +48 -5
67 lines not on this page · raw message
mm/Kconfig +11 -0
@@ -170,6 +170,17 @@ config ARCH_CPU_PROBE_RELEASE is for cpu hot-add/hot-remove to specified node in software method. This is for debuging and testing purpose +config ARCH_MEMORY_PROBE + def_bool y + bool "Memory hotplug emulation" + depends on NUMA_HOTPLUG_EMU + ---help--- + Enable memory hotplug emulation. Reserve memory with grub parameter + "mem=N"(such as mem=1024M), where N is the initial memory size, the + rest physical memory will be removed from e820 table; the memory probe + interface is for memory hot-add to specified node in software method. + This is for debuging and testing purpose + # # If we have space for more page flags then we can enable additional # optimizations and functionality.
Signature · 2 lines
Thanks & Regards, Shaohui