Skip to contentSkip to conversation

failure to boot GuruPlug with v2010.12-rc2 .kwb

U-Boot Clint Adams 3 participants 3 messages Dec 5, 2010 – Dec 6, 2010

lore
Share & tools
lore
#0 lore raw

Loading the ELF v2010.12-rc2 into RAM with OpenOCD works to boot my GuruPlug, but flashing the u-boot.kwb to /dev/mtd0 results in a brick.

What might be the problem here?

#1 lore raw

Le 05/12/2010 02:27, Clint Adams a ?crit :

Quoted 4 lines

Loading the ELF v2010.12-rc2 into RAM with OpenOCD works to boot my GuruPlug, but flashing the u-boot.kwb to /dev/mtd0 results in a brick.

What might be the problem here?

There are a couple of fixes to ARM boards which were not in 2010.12-rc2 and may not even be on master actually. Look up Andreas' patches for r8 preservation, notably. These may not solve your problem but they're needed anyway.

Amicalement,

Signature · 1 line
Albert.
#2 lore raw
In reply to Clint Adams
Quoted 9 lines

-----Original Message-----
From: u-boot-bounces at lists.denx.de [mailto:u-boot-bounces at lists.denx.de] On Behalf Of Clint Adams
Sent: Sunday, December 05, 2010 6:58 AM
To: u-boot at lists.denx.de
Subject: [U-Boot] failure to boot GuruPlug with v2010.12-rc2 .kwb

Quoted 4 lines

Loading the ELF v2010.12-rc2 into RAM with OpenOCD works to boot my GuruPlug, but flashing the u-boot.kwb to /dev/mtd0 results in a brick.

What might be the problem here?

I will cross check this, BTW: I have checked with Sheevaplug and boots properly.

Regards..
Prafulla . .