Skip to contentSkip to conversation

NEC OHCI chip bug

U-Boot Martin Mueller 2 participants 2 messages Dec 17, 2010 – Dec 21, 2010

lore
Share & tools
lore
#0 lore raw

Hi Gavin,

Quoted 6 lines
Quoted 3 lines

detection might work without PCI slave-initiated transfer and the root hub is OHCI internal. But - just guessing. If you have double checked the window there are no more ideas from my side.

Do you setup host bridge window base & size? Exactly, I didn??t set it before. Suppose, PCI devices on bus 0 should work, right ?

yes, usually at least size is set in a register. The documentation of your (PCI) hardware can be a valuable source of information here.

Regards,
Martin

#1 lore raw

Hi Martin,

2010/12/17 Martin Mueller <[email protected]>:

Quoted 11 lines

Hi Gavin,

Quoted 6 lines
Quoted 3 lines

detection might work without PCI slave-initiated transfer and the root hub is OHCI internal. But - just guessing. If you have double checked the window there are no more ideas from my side.

Do you setup host bridge window base & size? Exactly, I didn??t set it before. Suppose, PCI devices on bus 0 should work, right ?

yes, usually at least size is set in a register. The documentation of your (PCI) hardware can be a valuable source of information here.

This information really helps my colleague about the work of porting the component ftpci100. We are doing some hardware related configuration and digging out more details.

Thanks a lot.

Best regards,
Macpaul Lin