cs5535-gpio: don't apply errata #36 to edge detect GPIOs
PATCH 1/2 cs5535-gpio: don't apply errata #36 to edge detect GPIOs
Hi Linus,
These two should go in before 2.6.37; they fix regressions with 853ff883.
From: Andres Salomon <[email protected]>
The edge detect status GPIOs function differently from the other atomic model CS5536 GPIO registers; writing 1 to the high bits clears the GPIO, but writing 1 to the lower bits also clears the bit. This means that read-modify-write doesn't actually work for it, so don't apply the errata here. If a negative edge status gets lost after resume.. well, we tried our best!
Tested-by Daniel Drake <[email protected]>
Signed-off-by Andres Salomon <[email protected]>
--- drivers/gpio/cs5535-gpio.c | 15 +++++++++++---- 1 files changed, 11 insertions(+), 4 deletions(-)
drivers/gpio/cs5535-gpio.c +11 -4
@@ -56,15 +56,22 @@ static struct cs5535_gpio_chip {* registers, see include/linux/cs5535.h. */ -static void errata_outl (u32 val,unsigned long addr) +static void errata_outl (struct cs5535_gpio_chip *chip,u32 val, +unsigned int reg) { +unsigned long addr = chip->base +0x80 + reg; +/* * According to the CS5536 errata (#36), after suspend * a write to the high bank GPIO register will clear all * non-selected bits; the recommended workaround is a * read-modify-write operation. +* +* Don't apply this errata to the edge status GPIOs, as writing +* to their lower bits will clear them. */ - val |=inl (addr); +if (reg !=GPIO_POSITIVE_EDGE_STS && reg !=GPIO_NEGATIVE_EDGE_STS ) + val |=inl (addr);outl (val, addr); }
@@ -76,7 +83,7 @@ static void __cs5535_gpio_set(struct cs5535_gpio_chip *chip, unsigned offset,outl (1 << offset, chip->base + reg); else/* high bank register */ - errata_outl(1 << (offset - 16), chip->base + 0x80 + reg); + errata_outl(chip, 1 << (offset - 16), reg); }void cs5535_gpio_set (unsigned offset,unsigned int reg)
@@ -98,7 +105,7 @@ static void __cs5535_gpio_clear(struct cs5535_gpio_chip *chip, unsigned offset,outl (1 << (offset +16 ), chip->base + reg); else /* high bank register */ - errata_outl(1 << offset, chip->base + 0x80 + reg); + errata_outl(chip, 1 << offset, reg); } void cs5535_gpio_clear(unsigned offset, unsigned int reg)
Signature · 1 line
1.7.2.3