spi/pl022: remove dangling status check
PATCH 3/4 spi/pl022: remove dangling status check
From: Virupax Sadashivpetimath <[email protected]>
Signed-off-by Virupax Sadashivpetimath <[email protected]>
Signed-off-by Linus Walleij <[email protected]>
--- drivers/spi/amba-pl022.c | 2 -- 1 files changed, 0 insertions(+), 2 deletions(-)
drivers/spi/amba-pl022.c +0 -2
@@ -1906,8 +1906,6 @@ static int pl022_setup(struct spi_device *spi) && ((pl022->master_info)->enable_dma)) { chip->enable_dma = true;dev_dbg (&spi->dev,"DMA mode set in controller state\n" ); -if (status <0 ) - goto err_config_params;SSP_WRITE_BITS (chip->dmacr,SSP_DMA_ENABLED ,SSP_DMACR_MASK_RXDMAE ,0 ); SSP_WRITE_BITS(chip->dmacr, SSP_DMA_ENABLED,
Signature · 1 line
1.7.3.2
Grant Likely
AppliedPATCH 3/4 spi/pl022: remove dangling status check
Quoted 4 lines · Linus Walleij
From: Virupax Sadashivpetimath <[email protected]>
Signed-off-by Virupax Sadashivpetimath <[email protected]>Signed-off-by Linus Walleij <[email protected]>
Applied, thanks.
g.
Quoted 20 lines
--- drivers/spi/amba-pl022.c | 2 -- 1 files changed, 0 insertions(+), 2 deletions(-)drivers/spi/amba-pl022.c +0
-2@@ -1906,8 +1906,6 @@ static int pl022_setup(struct spi_device *spi) && ((pl022->master_info)->enable_dma)) { chip->enable_dma = true;dev_dbg (&spi->dev,"DMA mode set in controller state\n" ); -if (status <0 ) - goto err_config_params;SSP_WRITE_BITS (chip->dmacr,SSP_DMA_ENABLED ,SSP_DMACR_MASK_RXDMAE ,0 ); SSP_WRITE_BITS(chip->dmacr, SSP_DMA_ENABLED,Signature · 1 line
1.7.3.2