Skip to contentSkip to conversation

Add Board Support for Siemens L1 Board

PATCH New Manuel Traut 1 participant 1 message Apr 4, 2011

Subsystems (3)
lore
Share & tools
lore
#0 lore raw

PATCH 1/1 Add Board Support for Siemens L1 Board

Add Board Support for Siemens L1 Board

Siemens L1 is a ARM9 AT91 SAM9263 SoC based board with NOR Flash.

arch/arm/mach-at91/Kconfig +7 -0
Index: linux-2.6.39-rc1/arch/arm/mach-at91/Kconfig
===================================================================
@@ -318,6 +318,13 @@
 	help
 	  Select this if you are using the Adeneo Neocore 926 board.
 
+config MACH_SIEMENS_L1
+	bool "Siemens L1"
+ 	select HAVE_AT91_DATAFLASH_CARD
+ 	select HAVE_NAND_ATMEL_BUSWIDTH_16
+ 	help
+	  Select this if you are using the Siemens L1 board.
+
 endif
 
 # ----------------------------------------------------------
arch/arm/mach-at91/Makefile +1 -0
Index: linux-2.6.39-rc1/arch/arm/mach-at91/Makefile
===================================================================
@@ -56,6 +56,7 @@
 obj-$(CONFIG_MACH_AT91SAM9263EK) += board-sam9263ek.o
 obj-$(CONFIG_MACH_USB_A9263)	+= board-usb-a9263.o
 obj-$(CONFIG_MACH_NEOCORE926)	+= board-neocore926.o
+obj-$(CONFIG_MACH_SIEMENS_L1)	+= board-siemens-l1.o
 
 # AT91SAM9RL board-specific support
 obj-$(CONFIG_MACH_AT91SAM9RLEK)	+= board-sam9rlek.o
arch/arm/mach-at91/board-siemens-l1.c new file +166 -0

166 lines not on this page · raw message