cciss: resubmit add delay to PCI PM reset code
Subsystems (2)
PATCH 1/1 cciss: resubmit add delay to PCI PM reset code
PATCH 1 of 1
From: Mike Miller <[email protected]>
cciss: add delay back to PCI Power Management reset
When we change states from D0 to D3Hot and back to D0 we need a small delay. Otherwise we may think the board has failed to reset and we bail. This change affects the Smart Array P600.
Please ignore the previous patch that did this. I made it against the wrong code base resulting in an offset. My apologies.
Signed-off-by Mike Miller <[email protected]>
--- drivers/block/cciss.c | 2 +- 1 files changed, 1 insertions(+), 1 deletions(-)
drivers/block/cciss.c +1 -1
@@ -4526,13 +4526,13 @@ static int cciss_controller_hard_reset(struct pci_dev *pdev, pmcsr &= ~PCI_PM_CTRL_STATE_MASK ; pmcsr |= PCI_D3hot;pci_write_config_word (pdev, pos +PCI_PM_CTRL , pmcsr); -msleep (500 );/* enter the D0 power management state */ pmcsr &= ~PCI_PM_CTRL_STATE_MASK ; pmcsr |=PCI_D0 ;pci_write_config_word (pdev, pos +PCI_PM_CTRL , pmcsr); +msleep (500 ); }return 0 ; }