ASoC: Add support for TI LM49453 Audio codec
A message that is not in the archive (sent off-list or not yet received): [email protected]
Quoted 5 lines · M R Swami Reddy
---
Changes made in V2
o Removed fll and vco reference frequency settings from_set_dai_pll()
o Reworked chip enable and disable in_STANDBYand_OFFmodes inm49453_set_bias_level, as per the review comments.
You say this is version 2 but there's been rather more than two versions posted...
Review
Quoted 4 lines
(quoted diff) +4
-0+static int lm49453_set_dai_pll(struct snd_soc_dai *codec_dai, int pll_id, + int source, unsigned int freq_in, + unsigned int freq_out) +{
This is now a bit odd.
Review
Quoted 2 lines
(quoted diff) +2
-0+ state->in = freq_in; + state->out = freq_out;
It stores but otherwise ignores the configuration which was passed in (which seems more than a little odd).
Review
Quoted 13 lines
(quoted diff) +13
-0+ /* Always disable the PLL - it is not safe to leave it running + * while reprogramming it. + */ + snd_soc_update_bits(codec, LM49453_P0_PMC_SETUP_REG, + LM49453_PMC_SETUP_PLL_EN, 0); + + if (!freq_in || !freq_out) + return 0; + + + /* All done, turn it on */ + snd_soc_update_bits(codec, LM49453_P0_PMC_SETUP_REG, pwr_mask, + pwr_mask);
Then if the PLL was already enabled it bounces the power briefly. Really it seems like this should just be merged in with set_sysclk() - you're not actually configuring the PLL at all, just turning it on and off, at which point it's just another SYSCLK source.
Otherwise this seems good, just this clock configuration stuff to sort out.