multipath: adjust messages

PATCH New Benjamin Marzinski 1 participant 1 message Feb 10, 2012 Device mapper

Share & tools

Benjamin Marzinski

author maintainer

2012-02-10 18:16 UTC #0 lore raw

PATCH 1/1 multipath: adjust messages

Stop the rport_id messages from being dispalyed all the time, and add a message alerting users when multipath tries to setup a map and fails, or ends up removing the map.

Signed-off-by Benjamin Marzinski <[email protected]>

---
 libmultipath/configure.c |    3 +++
 libmultipath/discovery.c |    2 +-
 2 files changed, 4 insertions(+), 1 deletion(-)

libmultipath/configure.c +3 -0

Index: multipath-tools-120123/libmultipath/configure.c
===================================================================
@@ -576,6 +576,9 @@ coalesce_paths (struct vectors * vecs, v
 				   "for create/reload map",
 				mpp->alias, r);
 			if (r == DOMAP_FAIL) {
+				condlog(2, "%s: %s map",
+					mpp->alias, (mpp->action == ACT_CREATE)?
+					"ignoring" : "removing");
 				remove_map(mpp, vecs, 0);
 				continue;
 			} else /* if (r == DOMAP_RETRY) */

libmultipath/discovery.c +1 -1

Index: multipath-tools-120123/libmultipath/discovery.c
===================================================================
@@ -318,7 +318,7 @@ sysfs_set_scsi_tmo (struct multipath *mp
 	vector_foreach_slot(mpp->paths, pp, i) {
 		rport_id = find_rport_id(pp);
 		if (rport_id < 0) {
-			condlog(0, "failed to find rport_id for target%d:%d:%d", pp->sg_id.host_no, pp->sg_id.channel, pp->sg_id.scsi_id);
+			condlog(3, "failed to find rport_id for target%d:%d:%d", pp->sg_id.host_no, pp->sg_id.channel, pp->sg_id.scsi_id);
 			return 1;
 		}