README: supported boards are in boards.cfg, not Makefile
PATCH 1/1 README: supported boards are in boards.cfg, not Makefile
Signed-off-by Michael Jones <[email protected]>
--- README | 8 +++----- 1 files changed, 3 insertions(+), 5 deletions(-)
README +3 -5
@@ -3421,7 +3421,7 @@ is done by typing: make NAME_config where "NAME_config" is the name of one of the existing configu- -rations; see the main Makefile for supported names. +rations; see boards.cfg for supported names. Note: for some board special configuration names may exist; check if additional information is available from the board vendor; for
@@ -3476,10 +3476,8 @@ to port U-Boot to your hardware platform. To do this, follow these steps: 1. Add a new configuration option for your board to the toplevel - "Makefile" and to the "MAKEALL" script, using the existing - entries as examples. Note that here and at many other places - boards and other names are listed in alphabetical sort order. Please - keep this order. + "boards.cfg" file, using the existing entries as examples. + Follow the instructions there to keep the boards in order. 2. Create a new directory to hold your board specific code. Add any files you need. In your board directory, you will need at least the "Makefile", a "<board>.c", "flash.c" and "u-boot.lds".
Signature · 6 lines
1.7.4.1 MATRIX VISION GmbH, Talstrasse 16, DE-71570 Oppenweiler Registergericht: Amtsgericht Stuttgart, HRB 271090 Geschaeftsfuehrer: Gerhard Thullner, Werner Armingeon, Uwe Furtner, Erhard Meier
PATCH 1/1 README: supported boards are in boards.cfg, not Makefile
Quoted 5 lines · On Fri, 16 Mar 2012 09:48:10 +0100 Michael Jones…
Signed-off-by Michael Jones <[email protected]>--- README | 8 +++----- 1 files changed, 3 insertions(+), 5 deletions(-)
Applied to u-boot-staging/agust at denx.de. Thanks.
Anatolij