Skip to contentSkip to conversation

mx28evk: Fix PSWITCH key position

PATCH New Fabio Estevam 2 participants 2 messages May 12, 2012

lore
Share & tools
lore

Fabio Estevam

author
#0 lore raw

PATCH 1/1 mx28evk: Fix PSWITCH key position

Fix the position for PSWITCH key.

The good benefit of doing this is that boot time is greatly reduced:
from 5 seconds to less then 1 second.

Signed-off-by Fabio Estevam <[email protected]>
---
 doc/README.mx28evk |    2 +-
 1 files changed, 1 insertions(+), 1 deletions(-)
doc/README.mx28evk +1 -1
index c6c3d37..571dfda 100644
@@ -17,7 +17,7 @@ Jumper configuration
 To boot MX28EVK from an SD card, set the boot mode DIP switches as:
 
    * Boot Mode Select: 1 0 0 1 (Boot from SD card Slot 0 - U42)
-   * JTAG PSWITCH RESET: To the left (reset enabled)
+   * JTAG PSWITCH RESET: To the right (reset disabled)
    * Battery Source: Down
    * Wall 5V: Up
    * VDD 5V: To the left (off)
Signature · 1 line
1.7.1
#1 lore raw

PATCH 1/1 mx28evk: Fix PSWITCH key position

Dear Fabio Estevam,

Quoted 15 lines

Fix the position for PSWITCH key.

The good benefit of doing this is that boot time is greatly reduced:
from 5 seconds to less then 1 second.

Signed-off-by Fabio Estevam <[email protected]>
---
 doc/README.mx28evk |    2 +-
 1 files changed, 1 insertions(+), 1 deletions(-)
doc/README.mx28evk +0 -0
index c6c3d37..571dfda 100644

doc/README.mx28evk Jumper configuration · line 23

Quoted 8 lines
doc/README.mx28evk +1 -1
@@ -17,7 +17,7 @@ Jumper configuration
 To boot MX28EVK from an SD card, set the boot mode DIP switches as:
 
    * Boot Mode Select: 1 0 0 1 (Boot from SD card Slot 0 - U42)
-   * JTAG PSWITCH RESET: To the left (reset enabled)
+   * JTAG PSWITCH RESET: To the right (reset disabled)
    * Battery Source: Down
    * Wall 5V: Up
    * VDD 5V: To the left (off)

Thanks

Acked-by Marek Vasut <[email protected]>

Best regards,
Marek Vasut