staging: comedi: cb_pcimdda: remove regs_badrindex and reg_sz from boardinfo
PATCH 26/35 staging: comedi: cb_pcimdda: remove regs_badrindex and reg_sz from boardinfo
The base address of the card is always found in pci resource 3. There is no need to carry this information in the boardinfo. The reg_sz is not used in the driver. Remove them.
Signed-off-by H Hartley Sweeten <[email protected]>
Cc Ian Abbott <[email protected]>
Cc Greg Kroah-Hartman <[email protected]>
--- drivers/staging/comedi/drivers/cb_pcimdda.c | 7 +------ 1 file changed, 1 insertion(+), 6 deletions(-)
drivers/staging/comedi/drivers/cb_pcimdda.c +1 -6
@@ -107,9 +107,6 @@ struct cb_pcimdda_board {unsigned short device_id;int ao_chans;int ao_bits; -int regs_badrindex;/* IO Region for the control, analog output, -and DIO registers */ -int reg_sz;/* number of bytes of registers in io region */ };static const struct cb_pcimdda_board cb_pcimdda_boards[] = {
@@ -118,8 +115,6 @@ static const struct cb_pcimdda_board cb_pcimdda_boards[] = { .device_id = PCI_ID_PCIM_DDA06_16, .ao_chans = 6, .ao_bits = 16, - .regs_badrindex = 3, - .reg_sz = 16, } };
@@ -252,7 +247,7 @@ static int cb_pcimdda_attach(struct comedi_device *dev, ret =comedi_pci_enable (pcidev, dev->board_name);if (ret)return ret; - dev->iobase =pci_resource_start (pcidev, thisboard->regs_badrindex); + dev->iobase =pci_resource_start (pcidev,3 ); ret =comedi_alloc_subdevices (dev,2 );if (ret)
Signature · 1 line
1.7.11