Skip to contentSkip to conversation

iproute2 (2012-11-08) and tunnel mode vti problems

DISCUSSION Stephen Hemminger 1 participant 1 message Nov 8, 2012 3 messages not in the archive

Subsystems (2)
lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): [email protected]

A message that is not in the archive (sent off-list or not yet received): [email protected]

A message that is not in the archive (sent off-list or not yet received): [email protected]

#3 lore raw
Quoted 6 lines

I have here some problems with the newest iproute2 taken from git today. I will play around with the new vti mode.

First problem ist after loading the ip_vti module I got an ioctl error on ip tunnel show:

Quoted 11 lines

---------------------------------------------------------------------
root@ipsec0:[~] > ip -V
ip utility, iproute2-ss121108
root@ipsec0:[~] > uname -a
Linux ipsec0 3.6.6 #1 SMP Tue Nov 6 16:21:05 CET 2012 i686 GNU/Linux root@ipsec0:[~] > modprobe ip_vti
root@ipsec0:[~] > ip tunnel show
ip_vti0: ioctl 89f4 failed: Invalid argument
ip_vti0: ip/ip remote any local any ttl inherit nopmtudisc key 0 root@ipsec0:[~] >
--------------------------------------------------------------------

Found the cause of the problem. It is a kernel issue.

The kernel implementation of VTI uses same flag bit as SIT tunnel, and 'ip tunnel show' is using SIT flag to decide whether to look up sit tunnel parameters, which fails on VTI.

It is a bug introduced in ioctl definition for VTI. Not sure what the best way to fix it is? Add more kludge code in ip command, or change definition of flag bit, and risk userspace ABI incompatibility.

Also, there is the issue that i_flags is a confusing mix of network byte order bits or'd with host byte order bits. The initial definition of SIT was broken long, long ago.

Copying netdev list.