arm: mxs: Update mxs_defconfig

Regenerate the mxs_defconfig to match recent kernel using the following commands:

make mxs_defconfig
make savedefconfig
cp defconfig arch/arm/configs/mxs_defconfig

Then enable these features:
- MTD block access
- UBI and UBIFS
- JFFS2
- EXT2 and EXT4
- AT24 EEPROM support
- Support for most of the SPI flashes
- Support for ethernet PHYs that are usually used on mxs designs

Signed-off-by Marek Vasut <[email protected]>

Cc Fabio Estevam <[email protected]>

Cc Shawn Guo <[email protected]>

---
 arch/arm/configs/mxs_defconfig |   63 +++++++++++++++++++---------------------
 1 file changed, 30 insertions(+), 33 deletions(-)

NOTE: The SGTL5000 is enabled by default, it's not enabled by hand thus not
listed above

arch/arm/configs/mxs_defconfig +2 -4

index 048aaca..9d30a6b 100644
@@ -1,5 +1,7 @@
 CONFIG_EXPERIMENTAL=y
 CONFIG_SYSVIPC=y
+CONFIG_NO_HZ=y
+CONFIG_HIGH_RES_TIMERS=y
 CONFIG_TASKSTATS=y
 CONFIG_TASK_DELAY_ACCT=y
 CONFIG_TASK_XACCT=y

@@ -8,7 +10,6 @@ CONFIG_IKCONFIG=y
 CONFIG_IKCONFIG_PROC=y
 # CONFIG_UTS_NS is not set
 # CONFIG_IPC_NS is not set
-# CONFIG_USER_NS is not set
 # CONFIG_PID_NS is not set
 # CONFIG_NET_NS is not set
 CONFIG_PERF_EVENTS=y

@@ -24,8 +25,6 @@ CONFIG_BLK_DEV_INTEGRITY=y
 CONFIG_ARCH_MXS=y
 CONFIG_MACH_MXS_DT=y
 # CONFIG_ARM_THUMB is not set
-CONFIG_NO_HZ=y
-CONFIG_HIGH_RES_TIMERS=y
 CONFIG_PREEMPT_VOLUNTARY=y
 CONFIG_AEABI=y
 CONFIG_AUTO_ZRELADDR=y

@@ -46,23 +45,31 @@ CONFIG_SYN_COOKIES=y
 CONFIG_CAN=m
 CONFIG_CAN_RAW=m
 CONFIG_CAN_BCM=m
-CONFIG_CAN_DEV=m
 CONFIG_CAN_FLEXCAN=m
 # CONFIG_WIRELESS is not set

arch/arm/configs/mxs_defconfig +25 -27

+# CONFIG_M25PXX_USE_FAST_READ is not set
+CONFIG_MTD_SST25L=y
 CONFIG_MTD_NAND=y
 CONFIG_MTD_NAND_GPMI_NAND=y
+CONFIG_MTD_UBI=y
+# CONFIG_BLK_DEV is not set
+CONFIG_EEPROM_AT24=y
+CONFIG_SCSI=y
+CONFIG_BLK_DEV_SD=y
 CONFIG_NETDEVICES=y
-CONFIG_NET_ETHERNET=y
 CONFIG_ENC28J60=y
-# CONFIG_NETDEV_1000 is not set
-# CONFIG_NETDEV_10000 is not set
+CONFIG_SMSC_PHY=y
+CONFIG_ICPLUS_PHY=y
+CONFIG_REALTEK_PHY=y
+CONFIG_MICREL_PHY=y
 # CONFIG_WLAN is not set
 # CONFIG_INPUT_MOUSEDEV_PSAUX is not set
 CONFIG_INPUT_EVDEV=m

@@ -89,21 +96,6 @@ CONFIG_SPI_MXS=y
 CONFIG_DEBUG_GPIO=y
 CONFIG_GPIO_SYSFS=y
 # CONFIG_HWMON is not set
-# CONFIG_MFD_SUPPORT is not set
-CONFIG_DISPLAY_SUPPORT=m
-# CONFIG_HID_SUPPORT is not set
-CONFIG_SOUND=y
-CONFIG_SND=y
-CONFIG_SND_TIMER=y
-CONFIG_SND_PCM=y
-CONFIG_SND_JACK=y
-CONFIG_SND_DRIVERS=y
-CONFIG_SND_ARM=y
-CONFIG_SND_SOC=y
-CONFIG_SND_MXS_SOC=y
-CONFIG_SND_SOC_MXS_SGTL5000=y
-CONFIG_SND_SOC_I2C_AND_SPI=y
-CONFIG_SND_SOC_SGTL5000=y
 CONFIG_REGULATOR=y
 CONFIG_REGULATOR_FIXED_VOLTAGE=y
 CONFIG_FB=y

@@ -115,13 +107,16 @@ CONFIG_BACKLIGHT_PWM=y
 CONFIG_FRAMEBUFFER_CONSOLE=y
 CONFIG_FONTS=y
 CONFIG_LOGO=y
+CONFIG_SOUND=y
+CONFIG_SND=y
+CONFIG_SND_SOC=y
+CONFIG_SND_MXS_SOC=y
+CONFIG_SND_SOC_MXS_SGTL5000=y
 CONFIG_USB=y
 CONFIG_USB_CHIPIDEA=y
 CONFIG_USB_CHIPIDEA_HOST=y
 CONFIG_USB_STORAGE=y
 CONFIG_USB_MXS_PHY=y
-CONFIG_SCSI=y
-CONFIG_BLK_DEV_SD=y
 CONFIG_MMC=y
 CONFIG_MMC_MXS=y
 CONFIG_NEW_LEDS=y

@@ -145,16 +140,23 @@ CONFIG_COMMON_CLK_DEBUG=y
 CONFIG_IIO=y
 CONFIG_PWM=y
 CONFIG_PWM_MXS=y
+CONFIG_EXT2_FS=y
+CONFIG_EXT2_FS_XATTR=y
 CONFIG_EXT3_FS=y
+CONFIG_EXT4_FS=y
 # CONFIG_DNOTIFY is not set
 CONFIG_FSCACHE=m
 CONFIG_FSCACHE_STATS=y
 CONFIG_CACHEFILES=m
 CONFIG_TMPFS=y
 CONFIG_TMPFS_POSIX_ACL=y
-# CONFIG_MISC_FILESYSTEMS is not set
+CONFIG_JFFS2_FS=y
+CONFIG_JFFS2_COMPRESSION_OPTIONS=y
+CONFIG_JFFS2_LZO=y
+CONFIG_JFFS2_RUBIN=y
+CONFIG_UBIFS_FS=y
+CONFIG_UBIFS_FS_ADVANCED_COMPR=y
 CONFIG_NFS_FS=y
-CONFIG_NFS_V3=y
 CONFIG_NFS_V3_ACL=y
 CONFIG_NFS_V4=y
 CONFIG_ROOT_NFS=y

@@ -164,17 +166,12 @@ CONFIG_MAGIC_SYSRQ=y
 CONFIG_UNUSED_SYMBOLS=y
 CONFIG_DEBUG_KERNEL=y
 CONFIG_LOCKUP_DETECTOR=y
-CONFIG_DETECT_HUNG_TASK=y
 CONFIG_TIMER_STATS=y
 CONFIG_PROVE_LOCKING=y
-CONFIG_DEBUG_SPINLOCK_SLEEP=y
 CONFIG_DEBUG_INFO=y
-CONFIG_SYSCTL_SYSCALL_CHECK=y
 CONFIG_BLK_DEV_IO_TRACE=y
 CONFIG_STRICT_DEVMEM=y
 CONFIG_DEBUG_USER=y
-CONFIG_CRYPTO=y
-CONFIG_CRYPTO_CRC32C=m
 # CONFIG_CRYPTO_ANSI_CPRNG is not set
 # CONFIG_CRYPTO_HW is not set
 CONFIG_CRC_ITU_T=m

Signature · 1 line

1.7.10.4

Fabio,

I do not think it's reasonable to ask Marek to drop this change from his patch, as the change is probably included here because of savedefconfig. So I will have to drop your patch below. Sorry.

[PATCH] ARM: mxs_defconfig: Fix MTD_M25P80 selection
http://article.gmane.org/gmane.linux.ports.arm.kernel/203788

Applied with one comment below to Fabio.

Shawn,

Quoted 1 line · Shawn Guo

Applied with one comment below to Fabio.

Which tree this was applied?

Quoted 6 lines

Shawn,

Quoted 1 line · Shawn Guo

Applied with one comment below to Fabio.

Which tree this was applied?

Just pushed out branch mxs/soc.

Shawn

Do you think this can be made a stable matter for 3.7 ? It's a defconfig update afterall and it help a great deal.

Quoted 2 lines

Do you think this can be made a stable matter for 3.7 ? It's a defconfig update afterall and it help a great deal.

No, I don't think so. Sorry.

Dear Shawn Guo,

Quoted 5 lines · Marek Vasut

Quoted 2 lines

Do you think this can be made a stable matter for 3.7 ? It's a defconfig update afterall and it help a great deal.

No, I don't think so. Sorry.

Was this patch ever applied? I can't find it in 3.8 nor in -next :-(

Quoted 9 lines

Dear Shawn Guo,

Quoted 5 lines · Marek Vasut

Quoted 2 lines

Do you think this can be made a stable matter for 3.7 ? It's a defconfig update afterall and it help a great deal.

No, I don't think so. Sorry.

Was this patch ever applied? I can't find it in 3.8 nor in -next :-(

Isn't it on mainline right now as 77d168a (ARM: mxs: Update mxs_defconfig)?