Skip to contentSkip to conversation

arm: omap: Remove apollon board support

PATCH New Kyungmin Park 3 participants 3 messages Dec 26, 2012 – Feb 1, 2013

Subsystems (6)
Arm (32-bit) Arm sub-architectures Framebuffer layer OMAP2+ support +2 more subsystems
lore
Share & tools
lore

Kyungmin Park

author
#0 lore raw

PATCH 1/1 arm: omap: Remove apollon board support

From: Kyungmin Park <[email protected]>

As apollon board doesn't used anymore, remove it.

Signed-off-by Kyungmin Park <[email protected]>

---

arch/arm/mach-omap2/Kconfig +0 -6
index 41b581f..d4e4f95 100644
@@ -165,12 +165,6 @@ config MACH_OMAP_H4
 	select OMAP_DEBUG_DEVICES
 	select OMAP_PACKAGE_ZAF
 
-config MACH_OMAP_APOLLON
-	bool "OMAP 2420 Apollon board"
-	depends on SOC_OMAP2420
-	default y
-	select OMAP_PACKAGE_ZAC
-
 config MACH_OMAP_2430SDP
 	bool "OMAP 2430 SDP board"
 	depends on SOC_OMAP2430
arch/arm/mach-omap2/Makefile +0 -1
index a8004f3..25ca2a1 100644
@@ -220,7 +220,6 @@ endif
 obj-$(CONFIG_MACH_OMAP_GENERIC)		+= board-generic.o
 obj-$(CONFIG_MACH_OMAP_H4)		+= board-h4.o
 obj-$(CONFIG_MACH_OMAP_2430SDP)		+= board-2430sdp.o
-obj-$(CONFIG_MACH_OMAP_APOLLON)		+= board-apollon.o
 obj-$(CONFIG_MACH_OMAP3_BEAGLE)		+= board-omap3beagle.o
 obj-$(CONFIG_MACH_DEVKIT8000)     	+= board-devkit8000.o
 obj-$(CONFIG_MACH_OMAP_LDP)		+= board-ldp.o
arch/arm/mach-omap2/gpmc.c +0 -3
index 65468f6..ca7c5d4 100644
@@ -783,9 +783,6 @@ static int __devinit gpmc_mem_init(void)
 	 * even if we didn't boot from ROM.
 	 */
 	boot_rom_space = BOOT_ROM_SPACE;
-	/* In apollon the CS0 is mapped as 0x0000 0000 */
-	if (machine_is_omap_apollon())
-		boot_rom_space = 0;
 	gpmc_mem_root.start = GPMC_MEM_START + boot_rom_space;
 	gpmc_mem_root.end = GPMC_MEM_END;
arch/arm/mach-omap2/include/mach/uncompress.h +0 -1
index 8e3546d..e278451 100644
@@ -115,7 +115,6 @@ static inline void arch_decomp_setup(void)
 	do {
 		/* omap2 based boards using UART1 */
 		DEBUG_LL_OMAP2(1, omap_2430sdp);
-		DEBUG_LL_OMAP2(1, omap_apollon);
 		DEBUG_LL_OMAP2(1, omap_h4);
 
 		/* omap2 based boards using UART3 */
drivers/video/omap2/displays/panel-generic-dpi.c +0 -24
index 54ca8ae..c904f42 100644
@@ -291,30 +291,6 @@ static struct panel_config generic_dpi_panels[] = {
 		.name			= "h4",
 	},
 
-	/* Unknown panel used in Samsung OMAP2 Apollon */
-	{
-		{
-			.x_res		= 480,
-			.y_res		= 272,
-
-			.pixel_clock	= 6250,
-
-			.hsw		= 41,
-			.hfp		= 2,
-			.hbp		= 2,
-
-			.vsw		= 10,
-			.vfp		= 2,
-			.vbp		= 2,
-
-			.vsync_level	= OMAPDSS_SIG_ACTIVE_LOW,
-			.hsync_level	= OMAPDSS_SIG_ACTIVE_LOW,
-			.data_pclk_edge	= OMAPDSS_DRIVE_SIG_RISING_EDGE,
-			.de_level	= OMAPDSS_SIG_ACTIVE_HIGH,
-			.sync_pclk_edge	= OMAPDSS_DRIVE_SIG_OPPOSITE_EDGES,
-		},
-		.name			= "apollon",
-	},
 	/* FocalTech ETM070003DH6 */
 	{
 		{
arch/arm/mach-omap2/board-apollon.c deleted +0 -342

342 lines not on this page · raw message