mx31pdk: Remove watchdog support
PATCH 1/1 mx31pdk: Remove watchdog support
The conversion of mx31pdk to SPL NAND fixed the boot issue, but we start seeing resets in loop, which prevents us from reaching the U-boot prompt.
Until the proper fix can be identified, disable watchdog, so that mx31pdk can be functional again.
--- include/configs/mx31pdk.h | 2 -- 1 file changed, 2 deletions(-)
include/configs/mx31pdk.h +0 -2
@@ -60,8 +60,6 @@#define CONFIG_MXC_UART #define CONFIG_MXC_UART_BASE UART1_BASE -#define CONFIG_HW_WATCHDOG -#define CONFIG_IMX_WATCHDOG #define CONFIG_MXC_GPIO #define CONFIG_HARD_SPI
Signature · 1 line
1.7.9.5
PATCH 1/1 mx31pdk: Remove watchdog support
Quoted 8 lines · Fabio Estevam
The conversion of mx31pdk to SPL NAND fixed the boot issue, but we start seeing resets in loop, which prevents us from reaching the U-boot prompt.
Until the proper fix can be identified, disable watchdog, so that mx31pdk can be functional again.
Signed-off-by Fabio Estevam <[email protected]>---
Hi Fabio,
Quoted 9 lines
include/configs/mx31pdk.h | 2 -- 1 file changed, 2 deletions(-)include/configs/mx31pdk.h +0
-0
include/configs/mx31pdk.h line 65
Quoted 8 lines
include/configs/mx31pdk.h +0
-2@@ -60,8 +60,6 @@#define CONFIG_MXC_UART #define CONFIG_MXC_UART_BASE UART1_BASE -#define CONFIG_HW_WATCHDOG -#define CONFIG_IMX_WATCHDOG #define CONFIG_MXC_GPIO #define CONFIG_HARD_SPI
Benoit's patchset will flow into the release - then this one should also be merged.
Best regards,
Stefano Babic
Signature · 5 lines
===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de =====================================================================
PATCH 1/1 mx31pdk: Remove watchdog support
In reply to Fabio EstevamHi Fabio,
Quoted 16 lines · Fabio Estevam
The conversion of mx31pdk to SPL NAND fixed the boot issue, but we start seeing resets in loop, which prevents us from reaching the U-boot prompt.
Until the proper fix can be identified, disable watchdog, so that mx31pdk can be functional again.
Signed-off-by Fabio Estevam <[email protected]>--- include/configs/mx31pdk.h | 2 -- 1 file changed, 2 deletions(-)include/configs/mx31pdk.h +0
-0
include/configs/mx31pdk.h line 65
Quoted 8 lines
include/configs/mx31pdk.h +0
-2@@ -60,8 +60,6 @@#define CONFIG_MXC_UART #define CONFIG_MXC_UART_BASE UART1_BASE -#define CONFIG_HW_WATCHDOG -#define CONFIG_IMX_WATCHDOG #define CONFIG_MXC_GPIO #define CONFIG_HARD_SPI
Applied to u-boot-arm/master, thanks!
Amicalement,
Signature · 1 line
Albert.