Skip to contentSkip to conversation

ARM: ux500: cut chip-select GPIOs from SSP device

PATCH New Linus Walleij 2 participants 2 messages May 29, 2013 Device tree bindings

lore
Share & tools
lore
#0 lore raw

PATCH 1/1 ARM: ux500: cut chip-select GPIOs from SSP device

From: Linus Walleij <[email protected]>

What GPIO pin is used with which device on the SSP/SPI bus is as board-specific as it gets, so it does not belong here in the core SoC file, and it is disabled so it doesn't hurt to delete this.

---
 arch/arm/boot/dts/dbx5x0.dtsi | 5 -----
 1 file changed, 5 deletions(-)
arch/arm/boot/dts/dbx5x0.dtsi +0 -5
index b4b542b..12f36d4 100644
@@ -589,11 +589,6 @@
 			#address-cells = <1>;
 			#size-cells = <0>;
 			status = "disabled";
-
-			// Add one of these for each child device
-			cs-gpios = <&gpio0 31 0x4 &gpio4 14 0x4 &gpio4 16 0x4
-				    &gpio6 22 0x4 &gpio7 0 0x4>;
-
 		};
 
 		uart at 80120000 {
Signature · 1 line
1.7.11.3
#1 lore raw

PATCH 1/1 ARM: ux500: cut chip-select GPIOs from SSP device

Quoted 6 lines · Linus Walleij

From: Linus Walleij <[email protected]>

What GPIO pin is used with which device on the SSP/SPI bus is as board-specific as it gets, so it does not belong here in the core SoC file, and it is disabled so it doesn't hurt to delete this.

Sounds fine.

Signature · 4 lines
Lee Jones
Linaro ST-Ericsson Landing Team Lead
Linaro.org ? Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog