Skip to contentSkip to conversation

i915, external VGA: output missdirected?

DISCUSSION Eckard Gerlach 1 participant 2 messages Aug 20, 2013

lore
Share & tools
lore
#0 lore raw

Hi,

I need help urgently, my external monitor 22" doesn't get a signal since I bootet my laptop Lenovo B560 with closed lid an set the 1680x1050 manually. I worked fine that whole day. But after rebooting after that event the VGA interface denys to give any signal to VGA. The VGA interface with the external 22" monitor worked fine for months.
I'm working with xubuntu. I installed xubuntu again on another partition - but the same fault. So its not fault of somewhat settings in xubuntu. I've Win7 installed, too. Win7 works, sends output to VGA but seems to be confused:
Win7 denies to make 1680x1050 , a screen appears only with maximum 1024x768 but Win7 claims with a popup message, that 1680x1050 is the best. It seems that the VGA is redirected to the LVDS1 laptop screen and is "misunderstood". Is there somewhat BIOS on the i915 graphics card that I need to clear?

~$ xrandr
Screen 0: minimum 320 x 200, current 1366 x 768, maximum 8192 x 8192 LVDS1 connected 1366x768+0+0 (normal left inverted right x axis y axis) 344mm x 193mm

   1366x768       60.0*+
   1360x768       59.8     60.0
   1024x768       60.0
   800x600        60.3     56.2
   640x480        59.9
VGA1 connected (normal left inverted right x axis y axis)
   1680x1050      60.0 +
   1600x1200      60.0
   1280x1024      75.0     60.0
   1440x900       75.0
   1280x960       60.0
   1152x864       75.0
   1280x720       60.0
   1024x768       75.1     70.1     66.0     60.0
   832x624        74.6
   800x600        72.2     75.0     60.3     56.2
   640x480        72.8     75.0     66.7     60.0
   720x400        70.1

The command xrandr --output VGA1 --mode 1680x1050 makes a virtual 1680x1050 desktop on the laptop screen, NOT on the external monitor. The VGA output seems to be cut.

Please help, I need the external VGA urgently.

thx
Eckard

#1 lore raw

The dimension 1024x786 works, wonderful, fist step is done. How can I convince the chipset to drive a external monitor and not a projector, that make maximum 1024x786?
Same behaviour with Win7!! So it MUST be a chipset programming fault. Or a broken/ crashed chipset?