powerpc/powernv: Reduce panic timeout from 180s to 10s
PATCH 1/1 powerpc/powernv: Reduce panic timeout from 180s to 10s
We made this change to pseries in 2011 and I think it makes sense to do the same on powernv.
---
arch/powerpc/platforms/powernv/setup.c +2 -0
@@ -37,6 +37,8 @@static void __init pnv_setup_arch (void ) { + panic_timeout =10 ; +/* Initialize SMP */ pnv_smp_init ();
Quoted 3 lines · Anton Blanchard
We made this change to pseries in 2011 and I think it makes sense to do the same on powernv.
I'd vote we set it to 10s for all 64-bit machines in arch/powerpc/kernel/setup_64.c.
cheers
Quoted 7 lines · Michael Ellerman
Quoted 3 lines · Anton Blanchard
We made this change to pseries in 2011 and I think it makes sense to do the same on powernv.
I'd vote we set it to 10s for all 64-bit machines in
arch/powerpc/kernel/setup_64.c.
Why is 64-bit relevant? And wouldn't such a short delay be a problem if the crash is displayed on a monitor?
-Scott
Quoted 9 lines
Quoted 6 lines
Quoted 3 lines
We made this change to pseries in 2011 and I think it makes sense to do the same on powernv.
I'd vote we set it to 10s for all 64-bit machines in
arch/powerpc/kernel/setup_64.c.Why is 64-bit relevant? And wouldn't such a short delay be a problem if the crash is displayed on a monitor?
That is why we made it pseries specific in the past. Almost all our boxes are on a virtual console and the 3 minutes of pausing just hurt our uptimes.
If other platform maintainers prefer to keep the 3 minute pause, then we just change the PowerNV platform.
Anton