ahci: set ahci mode on reset
PATCH 1/1 ahci: set ahci mode on reset
ATM we set AHCI mode on 1st GHC write.
Spec says we should set it on reset.
Signed-off-by Michael S. Tsirkin <[email protected]>
--- hw/ide/ahci.c | 10 +++++++++- 1 file changed, 9 insertions(+), 1 deletion(-)
hw/ide/ahci.c +9 -1
@@ -1198,7 +1198,15 @@ void ahci_reset(AHCIState *s)int i; s->control_regs.irqstatus =0 ; - s->control_regs.ghc =0 ; +/* AHCI Enable (AE) +* The implementation of this bit is dependent upon the value of the +* CAP.SAM bit. If CAP.SAM is '0', then GHC.AE shall be read-write and +* shall have a reset value of '0'. If CAP.SAM is '1', then AE shall be +* read-only and shall have a reset value of '1'. +* +* We set HOST_CAP_AHCI so we must enable AHCI at reset. +*/ + s->control_regs.ghc =HOST_CTL_AHCI_EN ;for (i =0 ; i < s->ports; i++) { pr = &s->dev[i].port_regs;
Signature · 1 line
MST
Kevin Wolf
AppliedAm 28.09.2013 um 23:09 hat Michael S. Tsirkin geschrieben:
Quoted 4 lines
ATM we set AHCI mode on 1st GHC write.
Spec says we should set it on reset.Signed-off-by Michael S. Tsirkin <[email protected]>
Thanks, applied to the block branch.
Kevin