Documentation/Changes: update binutils version requirement for ARMv7 builds
PATCH 1/1 Documentation/Changes: update binutils version requirement for ARMv7 builds
ARMv7 builds now make use of the pldw opcode and the ".arch_extension mp" pragma. These aren't supported in binutils prior to 2.21. So, update Documentation/Changes accordingly.
---
Intended for 3.13.
Documentation/Changes | 3 +++ 1 file changed, 3 insertions(+)
Documentation/Changes +3 -0
@@ -67,6 +67,9 @@ assembling the 16-bit boot code, removing the need for as86 to compile your kernel. This change does, however, mean that you need a recent release of binutils. +ARMv7 builds require binutils 2.21 or later due to the use of the pldw +opcode and ".arch_extension mp". + Perl ----
Signature · 1 line
1.8.1.5
PATCH 1/1 Documentation/Changes: update binutils version requirement for ARMv7 builds
Quoted 8 lines · Paul Walmsley
ARMv7 builds now make use of the pldw opcode and the ".arch_extension mp" pragma. These aren't supported in binutils prior to 2.21. So, update
Documentation/Changesaccordingly.Signed-off-by Paul Walmsley <[email protected]>Cc Will Deacon <[email protected]>Cc Russell King <[email protected]>
You can drop this Cc: line, thanks.
Quoted 27 lines
Cc Stephen Warren <[email protected]>Cc Thierry Reding <[email protected]>Acked-by Russell King <[email protected]>---
Intended for 3.13.Documentation/Changes | 3 +++ 1 file changed, 3 insertions(+)Documentation/Changes +3
-0@@ -67,6 +67,9 @@ assembling the 16-bit boot code, removing the need for as86 to compile your kernel. This change does, however, mean that you need a recent release of binutils. +ARMv7 builds require binutils 2.21 or later due to the use of the pldw +opcode and ".arch_extension mp". + Perl ----Signature · 1 line
1.8.1.5
PATCH 1/1 Documentation/Changes: update binutils version requirement for ARMv7 builds
In reply to Paul WalmsleyQuoted 5 lines · Paul Walmsley
ARMv7 builds now make use of the pldw opcode and the ".arch_extension mp"
pragma. These aren't supported in binutils prior to 2.21. So, updateDocumentation/Changesaccordingly.
ARMv7 support didn't _exist_ in the minimal binutils version, and ARMv8 support is newer still. Hexagon, microblaze, they've all shown up in newer versions than the one that will build older architectures.
Annotating the global Documentation/Changes with every per-arch requirement... not sure that's the right place for it.
I also note that the FSF's toolchain seems to be losing steam again, and this time around EGCS is called LLVM. Now that http://ellcc.org is self-hosting (and can even build native toolchains as of
http://ellcc.org/blog/?p=251) all they need is http://lld.llvm.org to catch up and I think they've got a complete non-gnu toolchain capable of building a linux system. (It already contains musl-libc.org, I'm banging on toybox to provide a public domain busybox replacement...)
So there are larger issues in motion here. Noting armv7 requirements in an arm-specific file makes sense. Annotating the top level one raises the question of why not to do that for arc, unicore, openrisc, tile...
Rob
PATCH 1/1 Documentation/Changes: update binutils version requirement for ARMv7 builds
Quoted 12 lines · Rob Landley
Quoted 4 lines · Paul Walmsley
ARMv7 builds now make use of the pldw opcode and the ".arch_extension mp" pragma. These aren't supported in binutils prior to 2.21. So, update
Documentation/Changesaccordingly.ARMv7 support didn't _exist_ in the minimal binutils version, and ARMv8 support is newer still. Hexagon, microblaze, they've all shown up in newer versions than the one that will build older architectures.
Annotating the global
Documentation/Changeswith every per-arch requirement... not sure that's the right place for it.
...
Quoted 3 lines
So there are larger issues in motion here. Noting armv7 requirements in an arm-specific file makes sense. Annotating the top level one raises the question of why not to do that for arc, unicore, openrisc, tile...
Documenting some of the requirements in the top-level file and some in a per-arch file seems bad though. If we move the docs to a per-arch file, we need to actively remove the top-level documentation since it will conflict. What's wrong with a single table in the top-level document? The answer to missing requirements for the other arch seems to be to encourage the relevant maintainers to document them, not too disallow the ARM requirements to be documented there.
PATCH 1/1 Documentation/Changes: update binutils version requirement for ARMv7 builds
Quoted 22 lines · Stephen Warren
Quoted 3 lines · Rob Landley
Quoted 2 lines · Paul Walmsley
ARMv7 builds now make use of the pldw opcode and the
".arch_extension mp"
Quoted 1 line
Quoted 1 line
pragma. These aren't supported in binutils prior to 2.21. So,
update
Quoted 3 lines
Quoted 1 line
Documentation/Changesaccordingly.ARMv7 support didn't _exist_ in the minimal binutils version, and
ARMv8
Quoted 5 lines
support is newer still. Hexagon, microblaze, they've all shown up in newer versions than the one that will build older architectures.
Annotating the global
Documentation/Changeswith every per-arch requirement... not sure that's the right place for it....
Quoted 1 line
So there are larger issues in motion here. Noting armv7
requirements in
Quoted 1 line
an arm-specific file makes sense. Annotating the top level one
raises
Quoted 1 line
the question of why not to do that for arc, unicore, openrisc,
Quoted 8 lines
tile...
Documenting some of the requirements in the top-level file and some in a
per-arch file seems bad though. If we move the docs to a per-arch file,
we need to actively remove the top-level documentation since it will conflict.
No, you just need to document arch-specific deltas in arch-specific files.
You can build Linux with gcc 3.4. There was no ARMv7 support in gcc 3.4 (let alone 64 bit arm), but that doesn't change the fact that you can build Linux with it. Which is why it says "Upgrade to at *least* these software revisions".
If you're going to build Linux with llvm, you'll need a different version. If pcc manages to build linux (development of that's stalled but not stopped), then there's another one. If tinycc restarts...
Quoted 1 line
What's wrong with a single table in the top-level document?
So we haven't needed one for 20 years now, but your target is special?
The minimal requirements are the versions needed to build Linux at all, on any target, because there are generic features missing in earlier versions. Building Linux for a specific target often has more specific requirements.
Quoted 3 lines
The answer to missing requirements for the other arch seems to be to encourage the relevant maintainers to document them, not too disallow the ARM requirements to be documented there.
There's a Documentation/arm directory but arm-specific documentation can't go there, it has to go at the top level even though other architectures haven't previously done this. The alternative is that any global documentation that does NOT apply to arm must be deleted to avoid confusing arm.
Is this really your position?
One of the 8 gazillion todo items I have queued up is moving Documentation/zorro.txt to the Documentation/m68k directory. That's not the same as deleting the file because its existence might confuse ARM developers. I honestly think most of them are smarter than that.
Rob
PATCH 1/1 Documentation/Changes: update binutils version requirement for ARMv7 builds
In reply to Rob LandleyHi Rob,
Quoted 7 lines · Rob Landley
Quoted 4 lines · Paul Walmsley
ARMv7 builds now make use of the pldw opcode and the ".arch_extension mp"
pragma. These aren't supported in binutils prior to 2.21. So, updateDocumentation/Changesaccordingly.Annotating the global
Documentation/Changeswith every per-arch requirement... not sure that's the right place for it.
It doesn't matter to me where it's documented in the kernel documentation, but we should document it.
And we should expect folks who post patches with new toolchain constraints to also send patches for that documentation...
Quoted 3 lines
Noting armv7 requirements in
an arm-specific file makes sense. Annotating the top level one raises the question of why not to do that for arc, unicore, openrisc, tile...
Yes - it's the following x86-specific text in Documentation/Changes that inspired the patch:
-----
Linux on IA-32 has recently switched from using as86 to using gas for assembling the 16-bit boot code, removing the need for as86 to compile your kernel. This change does, however, mean that you need a recent release of binutils.
-----
But we can move that to Documentation/x86/ also.
regards,
- Paul
PATCH 1/1 Documentation/Changes: update binutils version requirement for ARMv7 builds
Quoted 10 lines · Paul Walmsley
Hi Rob,
Quoted 7 lines · Rob Landley
Quoted 6 lines · Paul Walmsley
ARMv7 builds now make use of the pldw opcode and the ".arch_extension
mp"
pragma. These aren't supported in binutils prior to 2.21. So, updateDocumentation/Changesaccordingly.
Quoted 5 lines
Quoted 2 lines
Annotating the global
Documentation/Changeswith every per-arch requirement... not sure that's the right place for it.It doesn't matter to me where it's documented in the kernel documentation, but we should document it.
Agreed, I'd just rather not add target-specific information to a file that currently has target-agnostic information.
A new file under Documentation/arm describing the build requirements for that platform would be nice. At some point I want to collate the target-specific directories under a Documentation/arch (so Documentation/arch/arm and Documentation/arch/m68k and so on, mirroring the source layout), but that's unrelated to this.
Quoted 3 lines
And we should expect folks who post patches with new toolchain constraints to also
send patches for that documentation...
Agreed.
Quoted 9 lines
Quoted 4 lines
Noting armv7 requirements in
an arm-specific file makes sense. Annotating the top level one raises the question of why not to do that for arc, unicore, openrisc, tile...Yes - it's the following x86-specific text in
Documentation/Changesthat inspired
the patch:
Quoted 6 lines
-----
Linux on IA-32 has recently switched from using as86 to using gas for assembling the 16-bit boot code, removing the need for as86 to compile your kernel. This change does, however, mean that you need a recent release of binutils.
-----
(Sigh, define "recent". Bisection search time, I suppose...)
Quoted 1 line
But we can move that to
Documentation/x86/also.
Agreed. Also the mcelog stuff looks x86-specific (or at least is currently documented as such). Also, I posted patches to remove the perl requirement but didn't remove the mention of perl from Documentation/Changes. I should fix that.
Also, Documentation/Changes is a weird name for the file describing the build environment requirements, but it's sort of grandfathered in at this point. That sort of implies I should add a Documentation/x86/Changes with the moved material, and the new arm file should be Documentation/arm/Changes. I suppose if the 00-INDEX clarifies that this describes the build environment requirements...
Which is worse, renaming a top level file that's been there for decades, or propagating the inaccurate name into subdirectories? Sigh, damned if you do...
Rob