Help needed to force USB host mode on AM335x CPU
We have a custom AM335x board where the USB0_ID pin has been left floating.
By default, this puts the USB controller into peripheral mode, but we need to force it into host mode.
This can be achieved in s/w by setting some bits in the relevant USB mode register (see TRM 16.5.2.35).
This mode register's offset is already defined in musb_dsps.c
static const struct dsps_musb_wrapper am33xx_driver_data = {
...
.mode = 0xe8,
...
};
I can manually set this register to the correct value in musb_host.c and the USB all seems to work as expected.
int musb_host_setup(struct musb *musb, int power_budget)
{
int ret;
struct usb_hcd *hcd = musb->hcd;/* Force HOST mode */
unsigned long __iomem *p;
p = ioremap(0x474010e8, 4);
*p = 0x80; /* IDDIG = 0, IDDIG_MUX = 1 */
MUSB_HST_MODE(musb);
...
};
Ideally I'd like to add an entry in my dts file to flag for this "force mode" to be setup, such as:-
usb@47401000 {
status = "okay";
dr_mode = "host";
ti,force-host; /* force host mode */
};Can anyone point me in the right direction as to where to put this extra code ?
I see there's a musb_am335x.c file, but that just seems to be a wrapper.
Any help would be greatly apperciated.
Regards
Mark J.
Hi,
Quoted 42 lines · Mark Jackson
We have a custom AM335x board where the
USB0_IDpin has been left floating.By default, this puts the USB controller into peripheral mode, but we need to force it into host mode.
This can be achieved in s/w by setting some bits in the relevant USB mode register (see TRM 16.5.2.35).
This mode register's offset is already defined in
musb_dsps.cstatic const struct
dsps_musb_wrapperam33xx_driver_data= {
....mode = 0xe8,...
};I can manually set this register to the correct value in
musb_host.cand the USB all seems to work as expected.int
musb_host_setup(struct musb *musb, int power_budget){ int ret; struct usb_hcd *hcd = musb->hcd;/* Force HOST mode */
unsigned long__iomem*p;
p =ioremap(0x474010e8, 4);
*p =0x80; /* IDDIG = 0,IDDIG_MUX= 1 */MUSB_HST_MODE(musb);...
};Ideally I'd like to add an entry in my dts file to flag for this "force mode" to be setup, such as:-
usb@47401000 { status = "okay"; dr_mode = "host"; ti,force-host; /* force host mode */ };
Quoted 5 lines
Can anyone point me in the right direction as to where to put this extra code ?
I see there's a
musb_am335x.cfile, but that just seems to be a wrapper.Any help would be greatly apperciated.
I just sent two patches to linux-usb and I suppose they can help. In fact, I remember now that I have to fix commit log on one of them. I'll do that now.
cheers
Signature · 1 line
balbi