Building and booting Barebox on Pandaboard
Dear all,
I am using barebox-2014.03.0 to try to boot on a Pandaboard ES. I have followed the instructions in the docs:
http://wiki.barebox.org/doku.php?id=boards:omap
I could not however find a barebox.bin.ift file in the output, so I guessed and went with the barebox-flash-image linked file and named it MLO.
It did not work. The Pandaboard ES did not boot.
Is the documentation outdated? Is there something else I should be doing?
Signature · 7 lines
Nur Hussein http://unixcat.org _______________________________________________ barebox mailing list [email protected] http://lists.infradead.org/mailman/listinfo/barebox
Hi,
Quoted 7 lines · Nur Hussein
Dear all,
I am using barebox-2014.03.0 to try to boot on a Pandaboard ES. I have followed the instructions in the docs:
http://wiki.barebox.org/doku.php?id=boards:omap
I could not however find a barebox.bin.ift file in the output, so I guessed and went with the barebox-flash-image linked file and named it MLO.
Yes, right. barebox-flash-image is the correct file to use. I updated this in the wiki.
Quoted 2 lines
It did not work. The Pandaboard ES did not boot.
Due to updates the panda_*defconfig configs currently do not build for the panda board. Please either manually call a make menuconfig and set the config back to panda:
System Type --->
OMAP Features --->
Select OMAP board (Texas Instrument's Panda Board) --->
Or apply the patch I just sent to the list:
ARM: Panda: Fix board selection in panda defconfig files
I'm not 100% sure the ES variant is supported. What was the difference between the ES and the regular board again? Does the ES have a omap4460 whereas the regular board has a omap4430? If yes then the ES should be supported.
Sascha
Signature · 9 lines
Pengutronix e.K. | | Industrial Linux Solutions | http://www.pengutronix.de/ | Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 | Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 | _______________________________________________ barebox mailing list [email protected] http://lists.infradead.org/mailman/listinfo/barebox
Hello,
Quoted 9 lines · Sascha Hauer
Due to updates the panda_*defconfig configs currently do not build for the panda board. Please either manually call a make menuconfig and set the config back to panda:
System Type --->
OMAP Features --->Select OMAP board (Texas Instrument's Panda Board) --->Or apply the patch I just sent to the list:
Thanks for the heads up. I shall try it and see if it works.
Quoted 6 lines
ARM: Panda: Fix board selection in panda defconfig files
I'm not 100% sure the ES variant is supported. What was the difference between the ES and the regular board again? Does the ES have a omap4460 whereas the regular board has a omap4430? If yes then the ES should be supported.
Yes, this is indeed the case.
Thank you for the reply and the patch.
Signature · 7 lines
Nur Hussein http://unixcat.org _______________________________________________ barebox mailing list [email protected] http://lists.infradead.org/mailman/listinfo/barebox