Skip to contentSkip to conversation

manual: (faq-boot-hang-after-starting) fix config entries

PATCH New Vivien Didelot 2 participants 2 messages Jun 18, 2014 – Jun 22, 2014

lore
Share & tools
lore

Vivien Didelot

author
#0 lore raw

PATCH v2 1/1 manual: (faq-boot-hang-after-starting) fix config entries

Signed-off-by Vivien Didelot <[email protected]>
---
 docs/manual/faq-troubleshooting.txt | 10 +++++-----
 1 file changed, 5 insertions(+), 5 deletions(-)
docs/manual/faq-troubleshooting.txt +5 -5
index 2fdb530..26c8460 100644
@@ -19,11 +19,11 @@ Starting dropbear sshd: generating rsa key... generating dsa key... OK
 
 then it means that your system is running, but didn't start a shell on
 the serial console. In order to have the system start a shell on your
-serial console, you have to go into the Buildroot configuration, +System
-configuration+, and modify +Port to run a getty (login prompt) on+ and
-+Baudrate to use+ as appropriate. This will automatically tune the
-+/etc/inittab+ file of the generated system so that a shell starts on
-the correct serial port.
+serial console, you have to go into the Buildroot configuration, in 
++System configuration+, modify +Run a getty (login prompt) after boot+ 
+and set the appropriate port and baud rate in the +getty options+ 
+submenu. This will automatically tune the +/etc/inittab+ file of the 
+generated system so that a shell starts on the correct serial port.
 
 [[faq-no-compiler-on-target]]
 == Why is there no compiler on the target?
Signature · 1 line
2.0.0
Applied
#1 lore raw

PATCH v2 1/1 manual: (faq-boot-hang-after-starting) fix config entries

Dear Vivien Didelot,

Quoted 4 lines · Vivien Didelot
Signed-off-by Vivien Didelot <[email protected]>
---
 docs/manual/faq-troubleshooting.txt | 10 +++++-----
 1 file changed, 5 insertions(+), 5 deletions(-)

Applied, thanks.

Thomas

Signature · 3 lines
Thomas Petazzoni, CTO, Free Electrons
Embedded Linux, Kernel and Android engineering
http://free-electrons.com