ebtables-compat: include /etc/ethertypes in tarball
PATCH 1/1 ebtables-compat: include /etc/ethertypes in tarball
The /etc/ethertypes file was originally distributed by the ebtables tarball. So, let's include the file also in ebtables-compat, so users can keep using protocol names instead of the hex code.
Signed-off-by Arturo Borrero Gonzalez <[email protected]>
---
NOTE: Should I create a make target to install the file with `make install'?
etc/ethertypes | 39 +++++++++++++++++++++++++++++++++++++++ 1 file changed, 39 insertions(+) create mode 100644 etc/ethertypes
etc/ethertypes new file +39 -0
@@ -0,0 +1,39 @@ +# +# Ethernet frame types +# This file describes some of the various Ethernet +# protocol types that are used on Ethernet networks. +# +# This list could be found on: +# http://www.iana.org/assignments/ethernet-numbers +# http://www.iana.org/assignments/ieee-802-numbers +# +# <name> <hexnumber> <alias1>...<alias35> #Comment +# +IPv4 0800 ip ip4 # Internet IP (IPv4) +X25 0805 +ARP 0806 ether-arp # +FR_ARP 0808 # Frame Relay ARP [RFC1701] +BPQ 08FF # G8BPQ AX.25 Ethernet Packet +DEC 6000 # DEC Assigned proto +DNA_DL 6001 # DEC DNA Dump/Load +DNA_RC 6002 # DEC DNA Remote Console +DNA_RT 6003 # DEC DNA Routing +LAT 6004 # DEC LAT +DIAG 6005 # DEC Diagnostics +CUST 6006 # DEC Customer use +SCA 6007 # DEC Systems Comms Arch +TEB 6558 # Trans Ether Bridging [RFC1701] +RAW_FR 6559 # Raw Frame Relay [RFC1701] +RARP 8035 # Reverse ARP [RFC903] +AARP 80F3 # Appletalk AARP +ATALK 809B # Appletalk +802_1Q 8100 8021q 1q 802.1q dot1q # 802.1Q Virtual LAN tagged frame +IPX 8137 # Novell IPX +NetBEUI 8191 # NetBEUI +IPv6 86DD ip6 # IP version 6 +PPP 880B # PPP +ATMMPOA 884C # MultiProtocol over ATM +PPP_DISC 8863 # PPPoE discovery messages +PPP_SES 8864 # PPPoE session messages +ATMFATE 8884 # Frame-based ATM Transport over Ethernet +LOOP 9000 loopback # loop proto
Pablo Neira Ayuso
maintainerQuoted 7 lines · Arturo Borrero Gonzalez
The
/etc/ethertypesfile was originally distributed by the ebtables tarball. So, let's include the file also in ebtables-compat, so users can keep using protocol names instead of the hex code.Signed-off-by Arturo Borrero Gonzalez <[email protected]>---
NOTE: Should I create a make target to install the file with `make install'?
Yes, please do so.
Make sure this only happens if ENABLE_NFTABLES is set.