Skip to contentSkip to conversation

ts5x00: remember to set the active flag

PATCH New Vivien Didelot 2 participants 2 messages Dec 23, 2014

lore
Share & tools
lore

Vivien Didelot

author
#0 lore raw

PATCH 1/1 ts5x00: remember to set the active flag

Signed-off-by Vivien Didelot <[email protected]>
---
 board/ts/ts5x00/readme.txt | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)
board/ts/ts5x00/readme.txt +2 -1
index a1d919e..1e50682 100644
@@ -43,7 +43,8 @@ Then install SYSLINUX in the mounted partition:
 IMPORTANT: In order for the board to boot the Compact Flash with a recent
 config, the BIOS must use Logical Block Addressing (LBA). You can do it by
 choosing "Ide 0: AUTOCONFIG, LBA" under "IDE DRIVE GEOMETRY" in the "Basic CMOS
-Configuration" screen. For details about the CMOS setup, please see:
+Configuration" screen. Also, don't forget to set the 'active' (or 'bootable')
+flag on partition 1. For details about the CMOS setup, please see:
 http://wiki.embeddedarm.com/wiki/TS-5500#System_BIOS_Setup_Screens
 
 Connect a terminal program to the rs232 connector marked "COM2"
Signature · 1 line
2.2.1
Applied
#1 lore raw

PATCH 1/1 ts5x00: remember to set the active flag

Dear Vivien Didelot,

Quoted 4 lines · Vivien Didelot
Signed-off-by Vivien Didelot <[email protected]>
---
 board/ts/ts5x00/readme.txt | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

Applied, thanks.

Thomas

Signature · 3 lines
Thomas Petazzoni, CTO, Free Electrons
Embedded Linux, Kernel and Android engineering
http://free-electrons.com