Skip to contentSkip to conversation

ARM: digicolor: add minimal device tree description

PATCH New Baruch Siach 2 participants 3 messages Jan 28, 2015 – Jan 29, 2015

Subsystems (5)
lore
Share & tools
lore

Baruch Siach

author maintainer
#0 lore raw

PATCH v4 1/2 ARM: digicolor: add minimal device tree description

cx92755.dtsi describes CX92755 on chip peripherals. cx92755_equinox.dts describes the Equinox evaluation board for the CX92755 SoC.

---
This is the only remaining part of the "ARM: Conexant Digicolor CX92755 SoC support" series. See v3 changelog at
http://article.gmane.org/gmane.linux.kernel/1865896.

v4:
* Rename conexant_equinox.dts to cx92755_equinox.dts which is closer to common practice (Olof Johansson)

* Add a syscon node; this is now required for the interrupt controller

* Decrease the registers range in the interrupt controller node to just the IC registers range. We now use syscon to access the global UC_IRQ_CONTROL register.

* Rename the interrupt controller node to "interrupt-controller" as per ePAPR

 arch/arm/boot/dts/Makefile            |   1 +
 arch/arm/boot/dts/cx92755.dtsi        | 113 ++++++++++++++++++++++++++++++++++
 arch/arm/boot/dts/cx92755_equinox.dts |  74 ++++++++++++++++++++++
 3 files changed, 188 insertions(+)
 create mode 100644 arch/arm/boot/dts/cx92755.dtsi
 create mode 100644 arch/arm/boot/dts/cx92755_equinox.dts
arch/arm/boot/dts/Makefile +1 -0
index 91bd5bd62857..71c69a271791 100644
@@ -75,6 +75,7 @@ dtb-$(CONFIG_ARCH_BRCMSTB) += \
 	bcm7445-bcm97445svmb.dtb
 dtb-$(CONFIG_ARCH_DAVINCI) += da850-enbw-cmc.dtb \
 	da850-evm.dtb
+dtb-$(CONFIG_ARCH_DIGICOLOR) += cx92755_equinox.dtb
 dtb-$(CONFIG_ARCH_EFM32) += efm32gg-dk3750.dtb
 dtb-$(CONFIG_ARCH_EXYNOS) += exynos3250-monk.dtb \
 	exynos3250-rinato.dtb \
arch/arm/boot/dts/cx92755.dtsi new file +113 -0

113 lines not on this page · raw message

arch/arm/boot/dts/cx92755_equinox.dts new file +74 -0

74 lines not on this page · raw message

Signature · 1 line
2.1.4
author maintainer
#1 lore raw

PATCH v4 2/2 ARM: digicolor: select syscon and timer

The digicolor interrupt controller driver now needs syscon.

Also, as per clocksource maintainer request, we now have a separate config symbol, CONFIG_DIGICOLOR_TIMER, for the digicolor timer.

---
v4:
New patch in this series

 arch/arm/mach-digicolor/Kconfig | 2 ++
 1 file changed, 2 insertions(+)
arch/arm/mach-digicolor/Kconfig +2 -0
index 5a0669a2738e..4f36d8d2bc57 100644
@@ -2,4 +2,6 @@ config ARCH_DIGICOLOR
 	bool "Conexant Digicolor SoC Support"
 	depends on ARCH_MULTI_V7
 	select CLKSRC_MMIO
+	select DIGICOLOR_TIMER
 	select GENERIC_IRQ_CHIP
+	select MFD_SYSCON
Signature · 1 line
2.1.4
#2 lore raw

PATCH v4 2/2 ARM: digicolor: select syscon and timer

Quoted 6 lines · Baruch Siach

The digicolor interrupt controller driver now needs syscon.

Also, as per clocksource maintainer request, we now have a separate config symbol, CONFIG_DIGICOLOR_TIMER, for the digicolor timer.

Thanks, applied 1-2.

-Olof