sata-fsl: Apply link speed limits
PATCH 1/1 sata-fsl: Apply link speed limits
The driver was ignoring limits requested by libata.force. The output would look like:
fsl-sata ffe18000.sata: Sata FSL Platform/CSB Driver init
ata1: FORCE: PHY spd limit set to 1.5Gbps
ata1: SATA max UDMA/133 irq 74
ata1: Signature Update detected @ 0 msecs
ata1: SATA link up 3.0 Gbps (SStatus 123 SControl 310)
Signed-off-by Martin Hicks <[email protected]>
--- drivers/ata/sata_fsl.c | 2 ++ 1 file changed, 2 insertions(+)
drivers/ata/sata_fsl.c +2 -0
@@ -868,6 +868,8 @@ try_offline_again:* PHY reset should remain asserted for atleast 1ms */ ata_msleep (ap,1 ); + +sata_set_spd (link);/* * Now, bring the host controller online again, this can take time
Signature · 10 lines
1.7.10.4 -- Martin Hicks P.Eng. | [email protected] Bork Consulting Inc. | +1 (613) 266-2296 _______________________________________________ Linuxppc-dev mailing list [email protected] https://lists.ozlabs.org/listinfo/linuxppc-dev
Tejun Heo
AppliedQuoted 5 lines · Martin Hicks
The driver was ignoring limits requested by libata.force. The output would look like:
Quoted 7 lines
fsl-sata ffe18000.sata: Sata FSL Platform/CSB Driver init
ata1: FORCE: PHY spd limit set to 1.5Gbps
ata1: SATA max UDMA/133 irq 74
ata1: Signature Update detected @ 0 msecs
ata1: SATA link up 3.0 Gbps (SStatus 123 SControl 310)Signed-off-by Martin Hicks <[email protected]>
Applied to libata/for-4.0-fixes.
Thanks.
Signature · 1 line
tejun