boards/raspberrypi: update readme with RPi-2 specifics
PATCH 1/1 boards/raspberrypi: update readme with RPi-2 specifics
The RPi-2 has its own DTB, so document it in the list of generated files.
Also, not all DTBs need to be present on the boot partition, so add a comment that identifies which should be copied for each model.
Signed-off-by "Yann E. MORIN" <[email protected]>
Cc Thomas Petazzoni <[email protected]>
--- board/raspberrypi/readme.txt | 16 ++++++++-------- 1 file changed, 8 insertions(+), 8 deletions(-)
board/raspberrypi/readme.txt +8 -8
@@ -62,8 +62,9 @@ After building, you should obtain this tree: output/images/ +-- rootfs.tar [0] +-- rpi-firmware/ - | +-- bcm2708-rpi-b.dtb [1] - | +-- bcm2708-rpi-b-plus.dtb [1] + | +-- bcm2708-rpi-b.dtb + | +-- bcm2708-rpi-b-plus.dtb + | +-- bcm2709-rpi-2-b.dtb | +-- bootcode.bin | +-- config.txt | +-- fixup.dat
@@ -73,10 +74,6 @@ After building, you should obtain this tree: [0] Note for Volatile: rootfs.tar will only be there if you kept "tar the root filesystem" option selected in "Filesystem images". -[1] The DTBs (Device Tree Blobs) will only be present if you setup - Buildroot to install the DTBs from the rpi-firmware package, and - will only be used if your kernel has support for the Device Tree. - Prepare you SDCard ==================
@@ -104,15 +101,18 @@ Install the binaries to the SDCard At the root of the boot partition, the Raspberry Pi must find the following files: - * bcm2708-rpi-b.dtb [2] + * bcm2708-rpi-b.dtb [1] * bcm2708-rpi-b-plus.dtb [2] + * bcm2709-rpi-2-b.dtb [3] * bootcode.bin * config.txt * fixup.dat * start.elf * zImage -[2] Only needed if your kernel has support for the Device Tree. +[1] For models A and B +[2] For models A+ and B+ +[3] For model 2 For example:
Signature · 1 line
1.9.1
Thomas Petazzoni
AppliedPATCH 1/1 boards/raspberrypi: update readme with RPi-2 specifics
Dear Yann E. MORIN,
Quoted 8 lines · Yann E. MORIN
The RPi-2 has its own DTB, so document it in the list of generated files.
Also, not all DTBs need to be present on the boot partition, so add a comment that identifies which should be copied for each model.
Signed-off-by "Yann E. MORIN" <[email protected]>Cc Thomas Petazzoni <[email protected]>
Applied, thanks.
Thomas
Signature · 3 lines
Thomas Petazzoni, CTO, Free Electrons Embedded Linux, Kernel and Android engineering http://free-electrons.com