ARM: dts: imx28: add alternative pinmuxing for spi3
Subsystems (2)
PATCH 1/1 ARM: dts: imx28: add alternative pinmuxing for spi3
Signed-off-by Uwe Kleine-K?nig <[email protected]>
---
Hello Shawn,
the .dts that uses this pinmuxing is for a customer board that is not supposed to go into mainline. Still the pinmuxing going in is very helpful because I cannot define it in the machine.dts.
So it would be great if you could pick this up even without an user.
Best regards
Uwe
arch/arm/boot/dts/imx28.dtsi | 13 +++++++++++++ 1 file changed, 13 insertions(+)
arch/arm/boot/dts/imx28.dtsi +13 -0
@@ -829,6 +829,19 @@ fsl,pull-up = <MXS_PULL_DISABLE>; }; + spi3_pins_b: spi3 at 1 { + reg = <1>; + fsl,pinmux-ids = < + MX28_PAD_SSP3_SCK__SSP3_SCK + MX28_PAD_SSP3_MOSI__SSP3_CMD + MX28_PAD_SSP3_MISO__SSP3_D0 + MX28_PAD_SSP3_SS0__SSP3_D3 + >; + fsl,drive-strength = <MXS_DRIVE_8mA>; + fsl,voltage = <MXS_VOLTAGE_HIGH>; + fsl,pull-up = <MXS_PULL_ENABLE>; + }; + usb0_pins_a: usb0 at 0 { reg = <0>; fsl,pinmux-ids = <
Signature · 1 line
2.1.4
Shawn Guo
AppliedPATCH 1/1 ARM: dts: imx28: add alternative pinmuxing for spi3
Quoted 9 lines · Uwe Kleine-K?nig
Signed-off-by Uwe Kleine-K?nig <[email protected]>---
Hello Shawn,the .dts that uses this pinmuxing is for a customer board that is not supposed to go into mainline. Still the pinmuxing going in is very helpful because I cannot define it in the
machine.dts.So it would be great if you could pick this up even without an user.
Applied, thanks.