Implementing a gpio based regulator with status pins
Hi all,
I have a system with a gpio based regulator which does not only have an enable pin, but also a status pin to report the actual power status. In some cases there may be a secondary status pin, making it possible to report on/off/error.
Some twist of this is that power activation time is not exactly well defined; activation can vary from board to board. I could of course use the existing (fixed) timeout supported by the regulator core, but it would be nice to be able to use an interrupt on the status pin(s), possibly with a timeout, to achieve a dynamic activation time.
The gpio pin(s) support interrupts, making it possible to report status updates, which might be useful if the power source goes bad or to support a dynamic power enable time.
As far as I can see, the existing gpio regulators don't implement status pins.
What would be the best way to implement this ?
- Add status support to the 'fixed' regulator
- Add status support to gpio-regulator.c
- Add (gpio) status support to the regulator core
- Write a new regulator driver
- Something else
Thanks,
Guenter
Quoted 7 lines · Guenter Roeck
What would be the best way to implement this ?
- Add status support to the 'fixed' regulator
- Add status support togpio-regulator.c
- Add (gpio) status support to the regulator core
- Write a new regulator driver
- Something else
I think this feature is common enough to warrant implementation in the core if you feel up to that.