ARM: imx53: include IRQ dt-bindings header
Subsystems (2)
PATCH 1/2 ARM: imx53: include IRQ dt-bindings header
Allows to use the more meaningful IRQ flag defines instead of the raw values.
Signed-off-by Lucas Stach <[email protected]>
--- arch/arm/boot/dts/imx53.dtsi | 1 + 1 file changed, 1 insertion(+)
arch/arm/boot/dts/imx53.dtsi +1 -0
@@ -15,6 +15,7 @@ #include <dt-bindings/clock/imx5-clock.h> #include <dt-bindings/gpio/gpio.h> #include <dt-bindings/input/input.h> +#include <dt-bindings/interrupt-controller/irq.h> / { aliases {
Signature · 1 line
2.4.6
PATCH 2/2 ARM: imx53: qsrb: fix PMIC interrupt level
The MC34708 PMIC interrupt level is active high, but was set to active low in the devicetree, probably as a result of a copy and paste error from the QSB board.
This caused IRQ storms and led to the kernel disabling the PMIC interrupt.
Signed-off-by Lucas Stach <[email protected]>
--- arch/arm/boot/dts/imx53-qsrb.dts | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
arch/arm/boot/dts/imx53-qsrb.dts +1 -1
@@ -48,7 +48,7 @@ pinctrl-0 = <&pinctrl_pmic>; reg = <0x08>; interrupt-parent = <&gpio5>; - interrupts = <23 0x8>; + interrupts = <23 IRQ_TYPE_LEVEL_HIGH>; regulators { sw1_reg: sw1a { regulator-name = "SW1";
Signature · 1 line
2.4.6
Shawn Guo
AppliedPATCH 1/2 ARM: imx53: include IRQ dt-bindings header
In reply to Lucas StachQuoted 4 lines · Lucas Stach
Allows to use the more meaningful IRQ flag defines instead of the raw values.
Signed-off-by Lucas Stach <[email protected]>
Applied both, thanks.