spi: zynq_qspi: Use __func__ on debug
Subsystems (2)
PATCH 1/1 spi: zynq_qspi: Use __func__ on debug
- Use __func__ on debug
- Removed unnecessary comment
--- drivers/spi/zynq_qspi.c | 8 +++----- 1 file changed, 3 insertions(+), 5 deletions(-)
drivers/spi/zynq_qspi.c +3 -5
@@ -430,7 +430,6 @@ static int zynq_qspi_start_transfer(struct zynq_qspi_priv *priv)zynq_qspi_fill_tx_fifo (priv, priv->fifo_depth);writel (ZYNQ_QSPI_IXR_ALL_MASK , ®s->ier); -/* Start the transfer by enabling manual start bit */ /* wait for completion */ do {
@@ -516,7 +515,7 @@ static int zynq_qspi_xfer(struct udevice *dev, unsigned int bitlen, priv->rx_buf = din; priv->len = bitlen /8 ; -debug ("spi_xfer: bus:%i cs:%i bitlen:%i len:%i flags:%lx\n" , +debug ("zynq_spi_xfer: bus:%i cs:%i bitlen:%i len:%i flags:%lx\n" , bus->seq, slave_plat->cs, bitlen, priv->len, flags);/*
@@ -569,8 +568,7 @@ static int zynq_qspi_set_speed(struct udevice *bus, uint speed)writel (confr, ®s->cr); priv->freq = speed; -debug ("zynq_spi_set_speed: regs=%p, speed=%d\n" , - priv->regs, priv->freq); +debug ("%s: regs=%p, speed=%d\n" , __func__, priv->regs, priv->freq);return 0 ; }
@@ -593,7 +591,7 @@ static int zynq_qspi_set_mode(struct udevice *bus, uint mode)writel (confr, ®s->cr); priv->mode = mode; -debug ("zynq_spi_set_mode: regs=%p, mode=%d\n" , priv->regs, priv->mode); +debug ("%s: regs=%p, mode=%d\n" , __func__, priv->regs, priv->mode);return 0 ; }
Signature · 1 line
1.9.1
PATCH 1/1 spi: zynq_qspi: Use __func__ on debug
Quoted 4 lines · Jagan Teki
- Use
__func__on debug
- Removed unnecessary commentSigned-off-by Jagan Teki <[email protected]>
Applied to u-boot-spi/master
Signature · 1 line
Jagan | openedev.
PATCH 1/1 spi: zynq_qspi: Use __func__ on debug
In reply to Jagan TekiQuoted 21 lines · Jagan Teki
- Use
__func__on debug
- Removed unnecessary commentSigned-off-by Jagan Teki <[email protected]>--- drivers/spi/zynq_qspi.c | 8 +++----- 1 file changed, 3 insertions(+), 5 deletions(-)drivers/spi/zynq_qspi.c +0
-1@@ -430,7 +430,6 @@ static int zynq_qspi_start_transfer(struct zynq_qspi_priv *priv)zynq_qspi_fill_tx_fifo (priv, priv->fifo_depth);writel (ZYNQ_QSPI_IXR_ALL_MASK , ®s->ier); -/* Start the transfer by enabling manual start bit */ /* wait for completion */ do {
drivers/spi/zynq_qspi.c static int zynq_qspi_xfer(struct udevice *dev, unsigned int bitlen, · line 519
Quoted 6 lines
drivers/spi/zynq_qspi.c +1
-1@@ -516,7 +515,7 @@ static int zynq_qspi_xfer(struct udevice *dev, unsigned int bitlen, priv->rx_buf = din; priv->len = bitlen /8 ; -debug ("spi_xfer: bus:%i cs:%i bitlen:%i len:%i flags:%lx\n" , +debug ("zynq_spi_xfer: bus:%i cs:%i bitlen:%i len:%i flags:%lx\n" , bus->seq, slave_plat->cs, bitlen, priv->len, flags);
Switch to __func__ here.
Signature · 8 lines
Tom -------------- next part -------------- A non-text attachment was scrubbed... Name: signature.asc Type: application/pgp-signature Size: 836 bytes Desc: Digital signature URL: <http://lists.denx.de/pipermail/u-boot/attachments/20151025/ddcde999/attachment.sig>
PATCH 1/1 spi: zynq_qspi: Use __func__ on debug
Quoted 26 lines · Tom Rini
Quoted 24 lines · Jagan Teki
- Use
__func__on debug
- Removed unnecessary commentSigned-off-by Jagan Teki <[email protected]>--- drivers/spi/zynq_qspi.c | 8 +++----- 1 file changed, 3 insertions(+), 5 deletions(-)drivers/spi/zynq_qspi.c +0
-1@@ -430,7 +430,6 @@ static int zynq_qspi_start_transfer(struct zynq_qspi_priv *priv)zynq_qspi_fill_tx_fifo (priv, priv->fifo_depth);writel (ZYNQ_QSPI_IXR_ALL_MASK , ®s->ier); -/* Start the transfer by enabling manual start bit */ /* wait for completion */ do {@@ -516,7 +515,7 @@ static int zynq_qspi_xfer(struct udevice *dev, unsigned int bitlen, priv->rx_buf = din; priv->len = bitlen /8 ;
Quoted 5 lines
drivers/spi/zynq_qspi.c static int zynq_qspi_xfer(struct udevice *dev, unsigned int bitlen, · line 519
Quoted 3 lines
drivers/spi/zynq_qspi.c +1
-1-debug ("spi_xfer: bus:%i cs:%i bitlen:%i len:%i flags:%lx\n" , +debug ("zynq_spi_xfer: bus:%i cs:%i bitlen:%i len:%i flags:%lx\n" , bus->seq, slave_plat->cs, bitlen, priv->len, flags);Switch to
__func__here.
Apologies for the mistake here will update the commit message on the branch.
Signature · 1 line
Jagan | openedev.
PATCH 1/1 spi: zynq_qspi: Use __func__ on debug
Quoted 27 lines · Jagan Teki
Quoted 26 lines · Tom Rini
Quoted 24 lines · Jagan Teki
- Use
__func__on debug
- Removed unnecessary commentSigned-off-by Jagan Teki <[email protected]>--- drivers/spi/zynq_qspi.c | 8 +++----- 1 file changed, 3 insertions(+), 5 deletions(-)drivers/spi/zynq_qspi.c +0
-1@@ -430,7 +430,6 @@ static int zynq_qspi_start_transfer(struct zynq_qspi_priv *priv)zynq_qspi_fill_tx_fifo (priv, priv->fifo_depth);writel (ZYNQ_QSPI_IXR_ALL_MASK , ®s->ier); -/* Start the transfer by enabling manual start bit */ /* wait for completion */ do {@@ -516,7 +515,7 @@ static int zynq_qspi_xfer(struct udevice *dev, unsigned int bitlen, priv->rx_buf = din; priv->len = bitlen /8 ;
Quoted 7 lines
Quoted 5 lines
drivers/spi/zynq_qspi.c static int zynq_qspi_xfer(struct udevice *dev, unsigned int bitlen, · line 519
Quoted 3 lines
drivers/spi/zynq_qspi.c +1
-1-debug ("spi_xfer: bus:%i cs:%i bitlen:%i len:%i flags:%lx\n" , +debug ("zynq_spi_xfer: bus:%i cs:%i bitlen:%i len:%i flags:%lx\n" , bus->seq, slave_plat->cs, bitlen, priv->len, flags);Switch to
__func__here.Apologies for the mistake here will update the commit message on the branch.
Well, not just the commit message but the debug() too, you say "zynq_spi_xfer" in "zynq_qspi_xfer" so we really do want __func__ ;)
Signature · 8 lines
Tom -------------- next part -------------- A non-text attachment was scrubbed... Name: signature.asc Type: application/pgp-signature Size: 836 bytes Desc: Digital signature URL: <http://lists.denx.de/pipermail/u-boot/attachments/20151025/cff54957/attachment.sig>
PATCH 1/1 spi: zynq_qspi: Use __func__ on debug
Quoted 34 lines · Tom Rini
Quoted 33 lines · Jagan Teki
Quoted 31 lines · Tom Rini
Quoted 21 lines · Jagan Teki
- Use
__func__on debug
- Removed unnecessary commentSigned-off-by Jagan Teki <[email protected]>--- drivers/spi/zynq_qspi.c | 8 +++----- 1 file changed, 3 insertions(+), 5 deletions(-)drivers/spi/zynq_qspi.c +0
-1@@ -430,7 +430,6 @@ static int zynq_qspi_start_transfer(struct zynq_qspi_priv *priv)zynq_qspi_fill_tx_fifo (priv, priv->fifo_depth);writel (ZYNQ_QSPI_IXR_ALL_MASK , ®s->ier); -/* Start the transfer by enabling manual start bit */ /* wait for completion */ do {drivers/spi/zynq_qspi.c static int zynq_qspi_xfer(struct udevice *dev, unsigned int bitlen, · line 519
Quoted 6 lines
drivers/spi/zynq_qspi.c +1
-1@@ -516,7 +515,7 @@ static int zynq_qspi_xfer(struct udevice *dev, unsigned int bitlen, priv->rx_buf = din; priv->len = bitlen /8 ; -debug ("spi_xfer: bus:%i cs:%i bitlen:%i len:%i flags:%lx\n" , +debug ("zynq_spi_xfer: bus:%i cs:%i bitlen:%i len:%i flags:%lx\n" , bus->seq, slave_plat->cs, bitlen, priv->len, flags);Switch to
__func__here.
Quoted 5 lines
Quoted 1 line
Apologies for the mistake here will update the commit message on the branch.
Well, not just the commit message but the
debug()too, you say "zynq_spi_xfer" in "zynq_qspi_xfer" so we really do want__func__;)
OK, _func__ not used here but for remaining speed and mode functions - Will update accordingly.
Signature · 1 line
Jagan | openedev.