fm10k: use BIT() macro instead of open-coded bit-shifting
Subsystems (2)
PATCH v2 1/1 fm10k: use BIT() macro instead of open-coded bit-shifting
Signed-off-by Bruce Allan <[email protected]>
--- drivers/net/ethernet/intel/fm10k/fm10k.h | 2 +- drivers/net/ethernet/intel/fm10k/fm10k_type.h | 2 +- 2 files changed, 2 insertions(+), 2 deletions(-)
drivers/net/ethernet/intel/fm10k/fm10k.h +1 -1
@@ -422,7 +422,7 @@ static inline u16 fm10k_desc_unused(struct fm10k_ring *ring) (&(((union fm10k_rx_desc *)((R)->desc))[i]))#define FM10K_MAX_TXD_PWR 14 -#define FM10K_MAX_DATA_PER_TXD (1 << FM10K_MAX_TXD_PWR) +#define FM10K_MAX_DATA_PER_TXD BIT(FM10K_MAX_TXD_PWR)/* Tx Descriptors needed, worst case */ #define TXD_USE_COUNT (S ) DIV_ROUND_UP((S), FM10K_MAX_DATA_PER_TXD)
drivers/net/ethernet/intel/fm10k/fm10k_type.h +1 -1
@@ -354,7 +354,7 @@ struct fm10k_hw;#define FM10K_VLAN_TABLE_VID_MAX 4096#define FM10K_VLAN_TABLE_VSI_MAX 64#define FM10K_VLAN_LENGTH_SHIFT 16 -#define FM10K_VLAN_CLEAR (1 << 15) +#define FM10K_VLAN_CLEAR BIT(15)#define FM10K_VLAN_ALL \ ((FM10K_VLAN_TABLE_VID_MAX - 1) << FM10K_VLAN_LENGTH_SHIFT)
Singh
PATCH v2 1/1 fm10k: use BIT() macro instead of open-coded bit-shifting
-----Original Message-----
From: Intel-wired-lan [mailto:intel-wired-lan-bounces at lists.osuosl.org] On Behalf Of Bruce Allan
Sent: Wednesday, October 28, 2015 5:20 PM
To: [email protected]
Subject: [Intel-wired-lan] [next-queue PATCH v2] fm10k: use BIT() macro instead of open-coded bit-shifting
Signed-off-by Bruce Allan <[email protected]>
---
Tested-by Krishneil Singh <[email protected]>