arm: socfpga: Fix QSPI doesn't work on socdk board

On Dec 22, 2015, at 05:22 PM, ?? ? <[email protected]> wrote:

On Dec 22, 2015, at 12:33 PM, Marek Vasut <[email protected]> wrote:

On Tuesday, December 22, 2015 at 09:19:16 PM, Marek Vasut wrote:

Quoted 10 lines · shengjiangwu

Updated pinmux group MIXED1IO[15-20] for QSPI. Updated QSPI clock.

Signed-off-by shengjiangwu <[email protected]>

Cc Chin Liang See <[email protected]>

Cc Dinh Nguyen <[email protected]>

Cc Dinh Nguyen <[email protected]>

Cc Pavel Machek <[email protected]>

Cc Marek Vasut <[email protected]>

Cc Stefan Roese <[email protected]>

Applied, thanks.

I will push your patches to [1] in a few hours, can you try and see if the CV SOCDK works fine for you? Thanks

[1] http://git.denx.de/?p=u-boot/u-boot-
socfpga.git;a=shortlog;h=refs/heads/master

Pushed. Please let me know how SoCDK works for you now and if there are still some problems.

Best regards,
Marek Vasut

Hi Marek,

Thank you for your help, I tested the master branch, emac1 and QSPI works. Below is log.

Best Regards,
ShengjiangWu

=> reset
resetting ...

U-Boot SPL 2016.01-rc2-09121-gc339ea5 (Dec 23 2015 - 09:13:52) drivers/ddr/altera/sequencer.c: Preparing to start memory calibration drivers/ddr/altera/sequencer.c: CALIBRATION PASSED drivers/ddr/altera/sequencer.c: Calibration complete Trying to boot from MMC

U-Boot 2016.01-rc2-09121-gc339ea5 (Dec 23 2015 - 09:13:52 +0800)

CPU: Altera SoCFPGA Platform
FPGA: Altera Cyclone V, SE/A6 or SX/C6 or ST/D6, version 0x0
BOOT: SD/MMC External Transceiver (1.8V)
Watchdog enabled
I2C: ready
DRAM: 1 GiB
MMC: dwmmc0 at ff704000: 0
*** Warning - bad CRC, using default environment

In: serial
Out: serial
Err: serial
Model: Altera SOCFPGA Cyclone V SoC Development Kit Net:
Error: ethernet at ff702000 address not set. No ethernet found.
Hit any key to stop autoboot: 0
=> env default -a
## Resetting to default environment
=> setenv netmask 255.255.254.0
=> setenv gatewayip 128.224.98.1
=> setenv ipaddr 128.224.98.85
=> setenv serverip 128.224.99.137
=> setenv ethaddr 00:04:9f:13:57:b4
=> saveenv
Saving Environment to MMC...
Writing to MMC(0)... done
=> reset
resetting ...

U-Boot SPL 2016.01-rc2-09121-gc339ea5 (Dec 23 2015 - 09:13:52) drivers/ddr/altera/sequencer.c: Preparing to start memory calibration drivers/ddr/altera/sequencer.c: CALIBRATION PASSED drivers/ddr/altera/sequencer.c: Calibration complete Trying to boot from MMC

U-Boot 2016.01-rc2-09121-gc339ea5 (Dec 23 2015 - 09:13:52 +0800)

CPU: Altera SoCFPGA Platform
FPGA: Altera Cyclone V, SE/A6 or SX/C6 or ST/D6, version 0x0
BOOT: SD/MMC External Transceiver (1.8V)
Watchdog enabled
I2C: ready
DRAM: 1 GiB
MMC: dwmmc0 at ff704000: 0
In: serial
Out: serial
Err: serial
Model: Altera SOCFPGA Cyclone V SoC Development Kit
Net: eth0: ethernet at ff702000
Hit any key to stop autoboot: 0
=> tftp 0x8000000 /tftpboot/altera/uVxWorks
Speed: 100, full duplex
Using ethernet at ff702000 device
TFTP from server 128.224.99.137; our IP address is 128.224.98.85 Filename '/tftpboot/altera/uVxWorks'.
Load address: 0x8000000
Loading: #################################################################
#################################################################
#################################################################
#################################################################
#################################################################
#################################################################
################################################
3.3 MiB/s
done
Bytes transferred = 6418496 (61f040 hex)
=> sf probe
SF: Detected N25Q1024 with page size 256 Bytes, erase size 64 KiB, total 128 MiB => sf read 0x7000000 0 0x60000
device 0 offset 0x0, size 0x60000
SF: 393216 bytes @ 0x0 Read: OK
=> md 0x7000000
07000000: ea00001a e59ff014 e59ff014 e59ff014 ................ 07000010: e59ff014 e59ff014 e59ff014 e59ff014 ................ 07000020: ffff0020 ffff0024 ffff0028 ffff002c ...$...(...,... 07000030: ffff0030 ffff0100 ffff0038 12345678 0.......8...xV4. 07000040: 31305341 2e160000 01390000 ea000007 AS01......9..... 07000050: 01000040 0000b854 0000b854 0000b900 @...T...T....... 07000060: 0000b854 0badc0de 0badc0de 0badc0de T............... 07000070: eb000040 e10f0000 e3c0001f e38000d3 @............... 07000080: e129f000 ee110f10 e3c00a02 ee010f10 ..)............. 07000090: e59f00a8 ee0c0f10 eb000008 eb000015 ................ 070000a0: eb000690 ee070f15 ee070f9a ee070f95 ................ 070000b0: e59f0088 ee0c0f10 e12fff1e e12fff1e ........../.../. 070000c0: e3a00000 ee080f17 ee070f15 ee070fd5 ................ 070000d0: ee070f9a ee070f95 ee110f10 e3c00a02 ................ 070000e0: e3c00007 e3800002 e3800b02 e3800a01 ................ 070000f0: ee010f10 e1a0f00e ea000018 e320f000 .............. . =>

BTW, I tested on master branch of u-boot-socfpga, not SoCDK.