sfc userland MCDI - request for guidance
Subsystems (2)
I have a design problem with a few possible solutions and I'd like some
guidance on which ones would be likely to be acceptable.
The sfc driver communicates with the hardware using a protocol called MCDI -
Management Controller to Driver Interface - and for various reasons (ranging from test automation to configuration utilities) we would like to be able to do this from userspace. We currently have two ways of handling this, neither of which is satisfactory.
One is to use libpci to talk directly to the hardware; however this is
unsafe when the driver is loaded because both driver and userland could try to send MCDI commands at the same time using the same doorbell.
The other is a private ioctl which is implemented in the out-of-tree version
of our driver. However, as an ioctl it presumably would not be acceptable in-tree.
The possible solutions we've come up with so far are:
* Generic Netlink. Define a netlink family for EFX_MCDI, registered at driver load time, and using ifindex to identify which device to send the MCDI to. The MCDI payload would be sent over netlink as a binary blob, because converting it to attributes and back would be much unnecessary work (there are many commands and many many arguments). The response from the hardware would be sent back to userland the same way.
* Sysfs. Have a sysfs node attached to the net device, to which MCDI commands are written and from which the responses are read. This does mean userland has to handle mutual exclusion, else it could get the response to another process's request.
* Have the driver reserve an extra VI ('Virtual Interface') on the NIC beyond its own requirements, and report the index of that VI in a sysfs node attached to the net device. Then the userland app can read it, and use that VI to do its MCDI through libpci. Since each VI has its own MCDI doorbell, this is safe, but involves libpci and requires that a VI always be reserved for this. Again, mutual exclusion is left to userspace.
* Have firmware expose a fake MTD partition, writes to which are interpreted as MCDI commands to run; no modification to the driver would be needed. This is incredibly ugly and our firmware team would rather not do it :)
Are any of these appropriate?
Quoted 8 lines · Fri, Jan 15, 2016 at 06:34:04PM CET, [email protected] wrote:
I have a design problem with a few possible solutions and I'd like some guidance on which ones would be likely to be acceptable.
The sfc driver communicates with the hardware using a protocol called MCDI - Management Controller to Driver Interface - and for various reasons (ranging from test automation to configuration utilities) we would like to be able to do this from userspace. We currently have two ways of handling this, neither of which is satisfactory.
It is wrong to send commands to HW directly to userspace. Please, do proper in-kernel vendor neutral feature abstraction and the implement in your driver. That is how things work. Userspace->HW bypass is simply unacceptable.