staging: nvec: Use the BIT macro
PATCH 1/1 staging: nvec: Use the BIT macro
Prefer using the BIT macro instead of (1 << X). Checkpatch detected this issue.
Signed-off-by Laura Garcia Liebana <[email protected]>
--- drivers/staging/nvec/nvec.c | 18 +++++++++--------- 1 file changed, 9 insertions(+), 9 deletions(-)
drivers/staging/nvec/nvec.c +9 -9
@@ -38,18 +38,18 @@#include "nvec.h" #define I2C_CNFG 0x00 -#define I2C_CNFG_PACKET_MODE_EN (1 << 10) -#define I2C_CNFG_NEW_MASTER_SFM (1 << 11) +#define I2C_CNFG_PACKET_MODE_EN BIT(10) +#define I2C_CNFG_NEW_MASTER_SFM BIT(11)#define I2C_CNFG_DEBOUNCE_CNT_SHIFT 12#define I2C_SL_CNFG 0x20 -#define I2C_SL_NEWSL (1 << 2) -#define I2C_SL_NACK (1 << 1) -#define I2C_SL_RESP (1 << 0) -#define I2C_SL_IRQ (1 << 3) -#define END_TRANS (1 << 4) -#define RCVD (1 << 2) -#define RNW (1 << 1) +#define I2C_SL_NEWSL BIT(2) +#define I2C_SL_NACK BIT(1) +#define I2C_SL_RESP BIT(0) +#define I2C_SL_IRQ BIT(3) +#define END_TRANS BIT(4) +#define RCVD BIT(2) +#define RNW BIT(1)#define I2C_SL_RCVD 0x24#define I2C_SL_STATUS 0x28
Signature · 1 line
2.7.0