ARM: dts: imx6qdl-sabresd: Pass the correct PCI reset polarity
Subsystems (2)
Fabio Estevam
reviewerPATCH 1/1 ARM: dts: imx6qdl-sabresd: Pass the correct PCI reset polarity
From: Fabio Estevam <[email protected]>
The PCI reset GPIO is active low, so represent it with the GPIO_ACTIVE_LOW flag.
Even though the imx6 PCI driver will not take the polarity into account in this case, it is better to provide a correct description in device-tree.
Signed-off-by Fabio Estevam <[email protected]>
--- arch/arm/boot/dts/imx6qdl-sabresd.dtsi | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
arch/arm/boot/dts/imx6qdl-sabresd.dtsi +1 -1
@@ -533,7 +533,7 @@ &pcie { pinctrl-names = "default"; pinctrl-0 = <&pinctrl_pcie>; - reset-gpio = <&gpio7 12 0>; + reset-gpio = <&gpio7 12 GPIO_ACTIVE_LOW>; status = "okay"; };
Signature · 1 line
1.9.1
Shawn Guo
AppliedPATCH 1/1 ARM: dts: imx6qdl-sabresd: Pass the correct PCI reset polarity
Quoted 9 lines · Fabio Estevam
From: Fabio Estevam <[email protected]>
The PCI reset GPIO is active low, so represent it with the
GPIO_ACTIVE_LOWflag.Even though the imx6 PCI driver will not take the polarity into account in this case, it is better to provide a correct description in device-tree.
Signed-off-by Fabio Estevam <[email protected]>
Applied, thanks.