implement gpio_pci_platform_pm to put pci device into D3cold
Dear all,
I want to solve one problem: we have pcie in a DT based arm64 system, now we want to put the device into D3cold when runtime suspended. The pcie device could be power down by operating one gpio pin, this is the D3cold the platform could support.
My solution is to register a gpio_pci_platform_pm with pci_set_platform_pm() but the key is how to setup a mapping between pci_dev and gpio through DT
I think this is a general case, could you please kindly give some suggestions?
Thanks,
Jisheng
Hi Jisheng,
Quoted 7 lines · Jisheng Zhang
Dear all,
I want to solve one problem: we have pcie in a DT based arm64 system, now we want to put the device into D3cold when runtime suspended. The pcie device could be power down by operating one gpio pin, this is the D3cold the platform could support.
Quoted 6 lines
My solution is to register a
gpio_pci_platform_pmwithpci_set_platform_pm()but the key is how to setup a mapping betweenpci_devand gpio through DTI think this is a general case, could you please kindly give some suggestions?
You would like to define an "equivalent" of what exists today in ACPI (ie ACPI methods like _PSx) through generic DT bindings, correct ?
It is hard to say what can be really generalized and how without having first an implementation (so that we can see how this would map to other systems), if you have some code to share even if it is an RFC that would help quite a bit.
Question: when you say "I think this is a general case" I wonder, are you referring to specific drivers in the mainline ?
Thanks,
Lorenzo