staging: dgnc: remove unused variable 'intr_modem'
Subsystems (2)
PATCH RESEND 10/15 staging: dgnc: remove unused variable 'intr_modem'
The 'intr_modem' variable was used only for increasing. So the 'intr_modem' variable is not useful for this driver.
Signed-off-by Daeseok Youn <[email protected]>
---
RESEND: This patch was not merged for a long time, if there is any reason why this patch could NOT be merged into staging tree, let me know. There were no comment for this patch.
I cannot understand why this patch have to wait long time to merge. And I also sent emails to mailing-lists for reminding this patch... please let me know, what is the problem to merge this patch into staging tree.
drivers/staging/dgnc/dgnc_cls.c | 1 - drivers/staging/dgnc/dgnc_driver.h | 1 - drivers/staging/dgnc/dgnc_neo.c | 1 - 3 files changed, 3 deletions(-)
drivers/staging/dgnc/dgnc_cls.c +0 -1
@@ -603,7 +603,6 @@ static inline void cls_parse_isr(struct dgnc_board *brd, uint port)/* CTS/RTS change of state */ if (isr &UART_IIR_CTSRTS ) { - brd->intr_modem++; ch->ch_intr_modem++;/* * Don't need to do anything, the cls_parse_modem
drivers/staging/dgnc/dgnc_driver.h +0 -1
@@ -183,7 +183,6 @@ struct dgnc_board {uint nasync;/* Number of ports on card */ uint irq;/* Interrupt request number */ -ulong intr_modem;/* Count of interrupts */ ulong intr_tx;/* Count of interrupts */ ulong intr_rx;/* Count of interrupts */
drivers/staging/dgnc/dgnc_neo.c +0 -1
@@ -452,7 +452,6 @@ static inline void neo_parse_isr(struct dgnc_board *brd, uint port)* If we get here, this means the hardware is doing auto flow control. * Check to see whether RTS/DTR or CTS/DSR caused this interrupt. */ - brd->intr_modem++; ch->ch_intr_modem++; cause =readb (&ch->ch_neo_uart->mcr);/* Which pin is doing auto flow? RTS or DTR? */
Signature · 1 line
1.9.1